Sealey LP170.V3 Manual

Refer toinstructionsElectricalshockhazardHot surfacesThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.Original Language Version© Jack Sealey Limited102,000-170,000BTU/HR (30-50KW) SPACEWARMER® PROPANE HEATERMODEL NO: LP170.V31. SAFETY1.1. ELECTRICAL SAFETY WARNING! It is the user’s responsibility to check the following:Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs andall electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electricalproducts. You may obtain an RCD by contacting your local Sealey dealer.If used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable Appliance Test) tested.It is important that the following information is read and understood.9 Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.9 regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.9 Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correct fuse - seefuse rating in these instructions.8 DO NOT pull or carry the appliance by the power cable.8 DO NOT pull the plug from the socket by the cable.8 DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired orreplaced immediately by a qualified electrician.9 This product is fitted with a BS1363/A 3 pin plug.If the cable or plug is damaged during use, switch the electricity supply and remove from use.Ensure that repairs are carried out by a qualified electrician.Replace a damaged plug with a BS1363/A 3 pin plug. If in doubt contact a qualified electrician.a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E ’.b) Connect the BROWN live wire to the live terminal ‘L’.c) Connect the BLUE neutral wire to the neutral terminal ‘N’.Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.Sealey recommend that repairs are carried out by a qualified ele ctrician.1.2. GENERAL SAFETY WARNING! Disconnect heater from mains electrical supply and gas cylinder before servicing or performingmaintenance. Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate thewarranty. WARNING! NOT to be used for the heating of habitable areas of domestic premises: for use in public buildings, refer to nationalregulations. WARNING! DO NOT use in basements or areas below ground level.9 Store gas cylinders in accordance with regulations applicable to such appliances.9 Ensure that nothing stands or passes in front of the heater. Minimum distance from the heater is 2 metres at the front, sides and rear0.65m and 0.95m above9 Only use the propane gas pressure regulator and hose assembly supplied with the heater, without alteration.9 Only use outdoors or in well ventilated surroundings in a well ventilated area away from combustible materials.9 Ensure continuous ventilation is provided to the heater operating area. A ventilation opening must run to the outside of the premiseswhere the heater is to be operated. The opening must be 100cm² for every kW and must also be set at an equal distance from theupper and lower parts of the heater operating area. WARNING! If the heater is used for prolonged periods at maximum power, ice may form on the propane cylinder. This is due toexcessive evaporation. In such a case DO NOT use the heater to de-ice the cylinder. WARNING! If the smell of gas is present, isolate the gas cylinder immediately and investigate reason before re-connecting it.8 DO NOT use the heater if damaged. Take immediate action to repair or replace damaged parts. Use an authorised service agent only.8 DO NOT use the heater for residential use or in recreational vehicles.8 DO NOT allow untrained persons to ignite the heater.8 DO NOT operate the heater without the cover.8 DO NOT use a naked flame to try and ignite the heater.8 DO NOT use the heater near flammable or explosive materials - liquids, solids or gases.8 DO NOT cover the heater whilst in use.8 DO NOT leave the heater unattended whilst in use.8 DO NOT obstruct the air inlet and outlet sections of the heater. Keep immediate area clean and tidy.8 DO NOT point the heater towards the gas cylinder.9 Keep children and vulnerable people away from the heater.Recommended fuse rating5 AmpKeep dryDo not coverThis product is not suitable for primary heating purposesLP170.V3 Issue: 2 (3) 25/08/22

/ 4

Related manuals for Sealey LP170.V3