Sealey LP14.V2 Instructions Manual

Also see for LP14.V2: Manual

Ceramic plaque type heater. Steel tube stand with built-in handle. Heat outputfrom 10,250to 15,354Btu/hr. Supplied with 37Mbar fixed regulator and 1.5mtrhose. Fully CE approved. Gas bottle not included.4.1. Contents4.1.1. Check content against the list below and, in the event of shortages ordamage, contact your supplier.Contents:• Heater stand and mounting bolts• Heater assembly• Hose and gas bottle regulatorfig.11.1. GENERAL SAFETY IMPORTANT: The LP14.V2 is a mobile, propane-fired, unvented, infrared space heater for commercial applications only. It is designed for usewith Propane cylinders of between 7kg to 15kg gas capacity. DO NOT use in a domestic environment. WARNING! Use only in well ventilated spaces of more than 15m³ to prevent an accumulation of dangerous combustion gases. DO NOT operate heater in basements or otherwise below ground level, in high rise flats, bathrooms or bedrooms. DO NOT operate heater in leisure vehicles such as caravans and autocaravans. WARNING! Heater will become very hot during use. WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment. Familiarise yourself with the application and limitations of the heater, as well as the potential hazards. WARNING! Disconnect the heater from the gas supply before performing any maintenance. Maintain the heater in good condition (use an authorised service agent). Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty. WARNING! Keep all guards and holding screws in place, tight and in good working order. The guard on this appliance is to prevent risk offire or injury from burns and no part of it should be permanently removed. IT DOES NOT GIVE FULL PROTECTION FOR YOUNGCHILDREN OR THE INFIRM. Check regularly for damaged parts. A guard or any other part that is damaged must be repaired or replacedbefore the heater is next used. Avoid twisting the regulator's flexible tube. The tube should be inspected for damage regularly and replacedif damage is found. Refer to the tube for its specification and length. Keep gas hose away from heat, oil and sharp edges. Ensure that all connections are secure. Keep the heater clean for best and safest performance. Ensure the propane bottle is in a stable upright position before igniting the heater. DO NOT use with the bottle in any position other than upright. DO NOT use any fuel other than propane. Ensure there are no flammable or combustible materials within 2 metres of the heater and that nothing, including walls, is less than 500mmfrom any surface of the heater. DO NOT use the heater where there are flammable liquids, solids or gases such as paint solvents, etc. DO NOT move the heater when it is operating. DO NOT use the heater for any purpose other than that for which it is designed. DO NOT operate the heater if any parts are damaged or missing as this may cause failure and/or personal injury. DO NOT adjust, or tamper with, the regulator. DO NOT allow untrained persons to operate the heater. DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication. When not in use disconnect from the gas supply and store in a safe, dry, childproof area. In the event of a gas leak immediately close the bottle valve, extinguish any flame and then place equipment in a well ventilated area,preferably outdoors, and away from any heat sources (including strong sunlight). Rectify cause of leakage. If a persistent leakage occurs notify a qualified service engineer. DANGER! If the burner remains alight after the bottle valve has been closed DO NOT attempt to remove burner and/or regulator from thebottle. Contact your gas supplier immediately. WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations thatmay occur. It must be understood by the operator that common sense and caution are factors which cannot be built intothis product, but must be applied by the operator.InSTRuCTIonS FoR:SPACE WARMER ® PROPANE HEATER10,250-15,354BTU/HR TRIPOD MOUNTEDMoDEL no: LP14.V21. SAFETYIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THEPRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.2. INTRODUCTION3. SPECIFICATIONModel No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LP14.V2Fuel. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PropaneOutput. . . . . . . . . . . . . . . . . . . . . . . . 10,250-15,354Btu/hrFuel Consumption. . . . . . . . . . . . . . . . . 0.220-0.330kg/hr4. CONTENTSOriginal Language Version© Jack Sealey Limited LP14.V2 ISSuE : 2(L) 23/07/14

/ 3

Related manuals for Sealey LP14.V2