Sealey LED307.V2 Quick Start Manual

Also see for LED307.V2: Manual Instruction manual

CORDLESS 24 SMD + 7 LED LITHIUM-IONRECHARGEABLE INSPECTION LAMPModel no: L ED307.V2Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAfETy1.1. GENERAL9 ensure the lamp is fully charged before initial use.8 DO NOT turn the lamp on when it is being charged.8 DO NOT shine directly into your, other person’s or animal’s eyes.8 DO NOT allow children to use the lamp.8 DO NOT handle or move the lamp whilst it is being charged.8 DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.8 DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequentlyrecharge the battery at least once every six months of non-use.1.2. ELECTRICAL SAfETy fOR USE Of CHARGER.USE ONLY THE SUPPLIED CHARGER PLUG FOR CONNECTING LAMP TO THE POWER SUPPLY. WARNING! It is the user’s responsibility to read, understand and comply with the following electrical instructions:You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCd(Residual Current device) is used with all electrical products, particularly portable equipment which is plugged into an electrical supplynot protected by an RCCB.you must also read and understand the following instructions concerning electrical safety.1.2.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualifiedelectrician, using a Portable Appliance Tester (PAT), at least once a year.1.2.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the applianceand the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.1.2.3. you must ensure that you:9 Inspect the charger plug, cable and connector for wear and damage to ensure items are safe before connecting to the mains powersupply. If worn or damaged DO NOT use.9 Important: Check that the voltage marked on the charger plug is the same as the lamp.9 Uncoil the cable between charger and the lamp.8 DO NOT pull the charger plug from the mains socket by the lead. WARNING! DO NOT use any other type of charger with this product, other than the supplied mains or car charger. failure toobserve this warning could result in injury and or fire and will invalidate the warranty.8 DO NOT try to take the charger plug apart.8 DO NOT use the charger plug to charge or power any other electrical item.8 DO NOT get the charger wet, or use in wet, damp conditions (for indoor use only).1.3 Battery Safety WARNING! To reduce the risk of burns or fire:8 DO NOT Attempt to open, disassemble, modify or service the battery pack.8 DO NOT Crush, puncture, short external contacts or dispose of in fire or water.8 DO NOT expose to temperatures above 60°C (140°).9 Replace only with the battery pack designated for this product.9 Recycle or dispose of used battery as stipulated by local regulation.9 If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with coolwater and seek immediate medical attention.2. INTRODUCTIONHeavy-duty housing features 37 super bright leds. 30 leds Used as an inspection lamp or 7 leds in the end for use as a directional torch.360° Hanging hook and magnet on rear of lamp for hands-free applications. Single led battery indicator. Supplied with 12V in-car charger andmains charger. Available with Schuko plug, order Model no. led307eU.led307.V2 Issue 3 (HF) 17/07/18Original Language Version© Jack Sealey limitedRefer toinstructions

/ 2

Related manuals for Sealey LED307.V2