Sealey LED307 Instruction Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONALREQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THEPURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONALINJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY1.1. GENERAL Ensure the lamp is fully charged before initial use. DO NOT turn the lamp on when it is being charged. DO NOT shine directly into your, other person’s oranimal’s eyes. DO NOT allow children to use the lamp. DO NOT handle or move the lamp whilst it is beingcharged. DO NOT use the lamp if you suspect that the battery orthe lamp casing is damaged. DO NOT leave battery in a discharged state, rechargebattery immediately. Before storage, fully recharge thebattery, subsequently recharge the battery at least onceevery six months of non-use.1.2. ELECTRICAL SAFETY FOR USE OF CHARGER.USE ONLY THE SUPPLIED CHARGER PLUG FORCONNECTING LAMP TO THE POWER SUPPLY. WARNING! It is the user’s responsibility to read,understand and comply with the following electricalinstructions:You must ensure the risk of electric shock is minimisedby the installation of appropriate safety devices.An RCCB (Residual Current Circuit Breaker) should beincorporated in the main distribution board. We alsorecommend that an RCD (Residual Current Device) isused with all electrical products, particularly portableequipment which is plugged into an electrical supply notprotected by an RCCB.You must also read and understand the followinginstructions concerning electrical safety.1.2.1. The Electricity At Work Act 1989 requires all portableelectrical appliances, if used on business premises, to betested by a qualified electrician, using a PortableAppliance Tester (PAT), at least once a year.1.2.2. The Health & Safety at Work Act 1974 makes ownersof electrical appliances responsible for the safe conditionof the appliance and the safety of the appliance operator.If in any doubt about electrical safety, contact aqualified electrician.1.2.3. You must ensure that you: Inspect the charger plug, cable and connector for wearand damage to ensure items are safe before connectingto the mains power supply.If worn or damaged DO NOT use. Important: Check that the voltage marked on the chargerplug is the same as the lamp. Uncoil the cable between charger and the lamp. DO NOT pull the charger plug from the mains socket bythe lead. WARNING! DO NOT use any other type of charger withthis product, other than the supplied mains or carcharger. Failure to observe this warning could result ininjury and or fire and will invalidate the warranty. DO NOT try to take the charger plug apart. DO NOT use the charger plug to charge or power anyother electrical item. DO NOT get the charger wet, or use in wet, dampconditions (for indoor use only).1.3 Battery Safety WARNING! To reduce the risk of burns or fire: DO NOT Attempt to open, disassemble, modify orservice the battery pack. DO NOT Crush, puncture, short external contacts ordispose of in fire or water. DO NOT Expose to temperatures above 60°C (140°). Replace only with the battery pack designated for thisproduct. Recycle or dispose of used battery as stipulated by localregulation. If the electrolyte in the cells gets on your skin, thoroughlywash with soap and water. If it gets in your eyes, rinsethoroughly with cool water and seek immediate medicalattentionHeavy-duty housing features 37 super bright LEDs. 30 LEDs used as an inspection lamp or 7 LEDs in the end for use as adirectional torch. 360° Hanging hook and magnet on rear of lamp for hands-free applications. Single LED battery indicator.Supplied with 12V in-car charger and mains charger.Battery: ..............................................................3.6V / 1200mAhCharging Time: .....................................................................5hrsOperating Time: ....................................................................5hrsLength..............................................................................210mm2. INTRODUCTION / SPECIFICATIONINSTRUCTION MANUAL FOR:CORDLESS 30 + 7 LED RECHARGEABLEINSPECTION LAMPMODEL No: LED307Original Language Version LED307 Issue: 2 - 25/10/11

/ 2

Related manuals for Sealey LED307