Sealey LED057 Instruction Manual

INSTRUCTIONS FOR:20W COB LED RECHARGEABLEFLOODLIGHT LITHIUM-ION CRI95MODEL No: LED0571.1. GENERAL Ensure the floodlight is correctly charged before initial use. DO NOT cover or block the lens during use. DO NOT turn the floodlight on when it is being re-charged. DO NOT shine directly into your, other person’s or animal’s eyes. DO NOT allow children to use the floodlight. DO NOT use the floodlight if you suspect that the battery or the spotlight casing is damaged. DO NOT immerse the floodlight in water. Be aware that the lamp housing will get hot during use. Ensure replacement batteries are genuine Sealey batteries of the same rating. Ensure the floodlight is unplugged and allowed to cool before attempting any cleaning or replacement. When not in use store the floodlight in a safe, dry, childproof location.1.2. BATTERY SAFETY WARNING! To reduce the risk of burns or fire: , DO NOT attempt to open, disassemble, modify or service the battery. Ensure the charger is switched off and disconnected from the floodlight before attempting to open the lamp unit. DO NOT expose to temperatures above 60°C (140°F). DO NOT crush, puncture, short external contacts or dispose of in fire or water. Replace only with the battery designated for this product. Dispose of the old batteries in accordance with local authority battery regulations. DO NOT dispose of with regular refuse. If the electrolyte in the cells contacts the skin, wash thoroughly with soap and water. If the electrolyte in the cells gets into the eyes, rinse thoroughly with cool water and seek immediate medical attention.1.3. ELECTRICAL SAFETYUSE ONLY THE SUPPLIED MAINS CHARGER PLUG FOR CONNECTING FLOODLIGHT TO THE MAINS POWERSUPPLY. ONLY USE THE SUPPLIED ADAPTOR FOR CONNECTING TO A VEHICLE 12V ACCESSORY SOCKET. WARNING! It is the user’s responsibility to read, understand and comply with the following electrical instructions:You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices. An RCCB (ResidualCurrent Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD (ResidualCurrent Device) is used with all electrical products, particularly portable equipment which is plugged into an electricalsupply not protected by an RCCB.You must also read and understand the following instructions concerning electrical safety.1.3.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested bya qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.1.3.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of theappliance and the safety of the appliance operator. If in any doubt about electrical safety, contact a qualifiedelectrician.1.3.3. You must ensure that you: Inspect the charger plug, cable and connector for wear and damage to ensure items are safe before connecting to themains power supply. If worn or damaged DO NOT use. Check cables are always protected against short circuit and overload. Important: Check that the voltage marked on the charger plug is the same as the power supply to be used. Uncoil the cable between charger and the floodlight. DO NOT pull the charger plug from the mains socket by the lead. DO NOT use any other type of charger with this product. DO NOT place the connector into any area of the floodlight except the correct jack inlet socket. DO NOT try to take the charger plug apart. DO NOT use the charger plug to charge or power any other electrical item. DO NOT get the charger wet, or use in wet, damp conditions (for indoor use only). WARNING! NEVER substitute a standard 13Amp 3 pin plug, or any other type of plug, for the charger plug.Original Language Version LED057 Issue: 1 - 03/09/15© Jack Sealey Limited1. SAFETYIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCTCORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILLINVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructionsand maintained properly, give you years of trouble free performance.Refer toInstruction Manual

/ 3

Related manuals for Sealey LED057