Menu
Sealey HST500 Instructions Manual
   |
1.1. ELECTRICAL SAFETY. p WARNING! It is the users responsibility to read, understand and comply with the following:You must check all electrical equipment and appliances to ensure they are safe before using. You must inspect power supply leads, plugs andall electrical connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of appropriate safetydevices. An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD(Residual Current Device) is used with all electrical products. It is particularly important to use an RCD together with portable products that areplugged into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You may obtain a Residual Current Deviceby contacting your Sealey dealer. You must also read and understand the following instructions concerning electrical safety.1.1.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on a business premises, to be tested bya qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.1.1.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the applianceand the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.1.1.3. Ensure the insulation on all cables and the product itself is safe before connecting to the mains powersupply. See 1.1.1. & 1.1.2. above and use a Portable Appliance Tester (PAT).1.1.4. Ensure that cables are always protected against short circuit and overload.1.1.5. Regularly inspect power supply leads, plugs for wear and damage and check all electrical connectionsto ensure that none is loose.1.1.6. Important: Ensure the voltage marked on the product is the same as the electrical power supplyto be used and check that plugs are fitted with the correct capacity fuse. A 13 amp plug may requirea fuse smaller than 13 amps for certain products (subject to 1.1.10. below) see fuse rating at right.1.1.7. DO NOT pull or carry the powered appliance by its power supply lead. Products such aswelders must not be pulled or carried by their output cables.1.1.8. DO NOT pull power plugs from sockets by the power cable.1.1.9. DO NOT use worn or damaged leads, plugs or connections. Immediately replace or have repaired bya qualified electrician. A U.K. 3 pin plug with ASTA/BS approval is fitted. In case of damage, cut offand fit a new plug according to the following instructions (discard old plug safely).(UK only - see diagram at right). Ensure the unit is correctly earthed via a three-pin plug.a) Connect the GREEN/YELLOW earth wire to the earth terminal E.b) Connect the BROWN live wire to live terminal L.c) Connect the BLUE neutral wire to the neutral terminal N.After wiring, check there are no bare wires, that all wires have been correctly connected, that the cable outer insulationextends beyond the cable restraint and that the cable restraint is tight.Double insulated products are often fitted with live (BROWN) and neutral (BLUE) wires only. Double insulated products are always marked withthis symbol . To re-wire, connect the brown & blue wires as indicated above. DO NOT connect the brown or blue to the earth terminal.1.1.10. Some products require more than a 13 amp electrical supply. In such a case, NO plug will be fitted. You must contact a qualified electricianto ensure a 30 amp fused supply is available. We recommend you discuss the installation of a industrial round pin plug and socket with your electrician.1.1.11. Cable extension reels. When a cable extension reel is used it should be fully unwound before connection. A cable reel with an RCDfitted is recommended since any product which is plugged into the cable reel will be protected. The section of the cores of the cableis important. We suggest at least 1.5mm2 section cable, but to be absolutely sure that the capacity of the cable reel issuitable for this product and for others that may be used in the other output sockets, we recommend the use of 2.5mm2 section cable.INSTRUCTIONS FOR:S T E A M C L E A N I N G S Y S T E MModel: HST500The use of symbols in this document is to attract your attention to possible danger. The symbols and warnings themselves do not eliminate any danger, nor are they substitutes for properaccident prevention measures.Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.HST500 - 0089 - (1) - 0909991. SAFETY INSTRUCTIONSIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSEDAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.BlueNeutralYellow & GreenEarth wireCablerestraiFUSE RATINGTHIS PRODUCT MUST BE FITTEDWITH A13 Amp FUSEBrownLivewire1.2 GENERAL SAFETY3 Familiarise yourself with this products application and limitations, as well as the specific potential hazards peculiar to the cleaner.p WARNING! Disconnect the cleaner from the mains power before servicing or performing any maintenance.3 Maintain the cleaner in good condition (use an authorised service agent).3 Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.3 Keep the unit clean for best and safest performance.7 DO NOT use the cleaner for any purpose other than for which it is designed.7 DO NOT operate the cleaner if any parts are damaged or missing as this may cause failure or possible personal injury.7 DO NOT adjust or tamper with the safety valve.7 DO NOT carry the by the hose or cable.7 DO NOT allow untrained persons to operate the cleaner.7 DO NOT operate the cleaner when you are tired, under the influence of alcohol, drugs or intoxicating medication.7 DO NOT leave the cleaner operating unattended.7 DO NOT direct steam/water from the hose at yourself or others.3 When not in use unplug from the mains power supply and store in a safe, dry, childproof area. |
Related manuals for Sealey HST500
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved