Menu
Sealey HP01 Instructions Manual
   |
INSTRUCTIONS FORGRAVITY SPRAY GUN 1.3MM SET-UPFINISHING COATMODEL NO: HP01Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY9 Familiarise yourself with the application and limitations, as well as the potential hazards of the spray gun. WARNING! Disconnect the spray gun from the air supply before changing accessories, servicing or performing any maintenance.9 Maintain the spray gun in good condition (use an authorised service agent).9 Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.9 Locate the spray gun in a suitable work area, keep area clean and tidy and free from unrelated materials, and ensure that there isadequate ventilation and lighting.9 Keep the spray gun clean for best and safest performance.9 Ensure the air system has sufficient output for the spray gun air consumption (see specification).9 Wear approved respiratory protection, safety eye goggles and skin protection.9 Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and tie back long hair.9 Keep children and unauthorised persons away from the work area.9 When gun is not in use ensure the air supply is disconnected.9 Avoid unintentional operation.8 DO NOT paint were there is any source, or possible source, of ignition as paint mist is extremely flammable.8 DO NOT point spray gun at yourself or at other persons or animals.8 DO NOT carry the spray gun by the air hose, or yank the hose from the air supply.8 DO NOT use the spray gun for any purpose other than for which it is designed.8 DO NOT allow untrained persons to operate the spray gun.8 DO NOT get the spray gun wet or use in damp or wet locations or areas where there is condensation.8 DO NOT operate gun if any parts are missing or damaged as this may cause failure and/or personal injury.8 DO NOT direct air from the air hose at yourself or others.2. INTRODUCTIONGravity feed spray gun designed for applying clear finishing coats. Air cap engineered to deliver high mist pressure for rapid paint applicationand extended working distance. Stainless steel air and laquer flow channels provides long life. Features air and laquer flow controls for fineadjustment of spray pattern.3. SPECIFICATIONSModel no: ..................................................................... HP01Standard set up: .......................................................... 1.3mmAir pressure:............................................................. 29-32psiAir consumption: ....................................................... 10.1cfmPot capacity: ................................................................ 600mlRefer toinstructionmanualHP01 Issue No:1 04/11/15Original Language Version© Jack Sealey LimitedWear eyeprotectionWearrespiratoryprotection |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved