Sealey HBS2001 Manual

Also see for HBS2001: Instructions

BODYSHOP/WORKSHOP HEADLAMPBEAM SETTERModel no: HBS2001Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAfETY8 DO NOT allow unqualified persons to operate the HBS.8 DO NOT use the HBS in direct sunlight.8 DO NOT splash the HBS with water or any other liquid.9 do ensure the work area is well ventilated.9 do ensure that there is good lighting.9 do apply handbrake on vehicle.9 do avoid sudden changes in temperature.9 do avoid sudden vibration.2. INTRODucTIONSuitable for pre-MOT inspection in garages and bodyshops. Utilises same optical box and aiming screen as fitted to our MOT approvedheadlamp beam setter. Fixed aiming screen. Internal analogue lUX meter for accurate light intensity measurement. Suitable for all types ofcars and light commercial vehicles. Fitted with fixed column and rubber wheels.3. SPEcIfIcATIONHeight ..........................................................................1750mmWidth .............................................................................660mmlength ...........................................................................620mmMaximum height of beam measurement .....................1500mmMinimum height of beam measurement ........................220mmFocal length ...................................................................500mm4. ASSEMBLY4.1. Figure 1A ...................................................................................... BASeB ................................................................................ ColUMnC ............................................... VeRTICAl SlIdInG SYSTeMd .....................................................................MIRRoR-VISoRe .................................................................oPTICAl SYSTeMF ..................................................................... leVeR SCReW4.2. Attach column B to base A using nuts, bolts and washers provided.Column should be positioned so that optical system mountingplate on sliding system C is facing the single wheel.4.3. Attach mirror-visor d to mounting plate at the top of column B with thetwo screws provided (in end of visor).4.4. Fit the optical system e to the vertical sliding system C using the two screws and washers provided (fit lever screw F and larger washerover slotted hole).5. PREPARATION fOR uSE5.1. Working Surface5.1.1. Position the vehicle on the designated headlamp aim standing area.5.1.2. When positioning the HBS ensure the floor is perfectly even and level.5.1.3. If this is not possible the vehicle and HBS must be on the same slope, which must not exceed 0.5º.5.1.4. Headlights must not be checked where surface angle exceeds 0.5º (see fig. 2).fig.1fig.2HBS2001 Issue 3 (HF) 14/08/18Original Language Version© Jack Sealey limitedRefer toinstructionsIndoor use onlyOK 0.5 0 MAX NO NO

/ 5

Related manuals for Sealey HBS2001