Sealey FSW80 Instructions Manual

INSTRUCTIONS FOR:FLOOR SWEEPER 800MMMODEL No. FSW80Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.1. SAFETY INSTRUCTIONS2. INTRODUCTIONIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSEDAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.3.1 Lower Handle: Take the lower handle tube and place the slots in theflattened ends over the threaded spigots on the handle brackets, see fig.1B.Ensure that the open slots at each end of the lower handle are engaged withthe plain spigot on the mounting brackets. Retain the handle in place byscrewing a black plastic knob onto each threaded spigot.3.2 Upper Handle: The upper handle has three alternative mounting holes in theflattened portions of the handle. Align the chosen mounting holes with theholes in the upper part of the lower handle and insert the supplied coachbolts through both frames and retain with the black plastic knobs supplied asshown in fig.1A.3.3 Handle stowage: The handle can be folded down for storage purposes.Loosen the lower mounting knobs and pull the handle upwards to disengagethe slotted ends from the plain spigots on the mounting brackets. Hinge thehandle forwards and allow it to rest on the body of the sweeper.3.4 Circular brushes: Attach each brush to its hub using the 6 screws provided(3 for each brush). Ensure each brush is correctly seated before tightening.3.5 Use: Ensure the handle height is correctly adjusted for the convenience ofthe operative. Make sure that the handle fixings are tight and the dirtcollection hopper is properly seated within the main body of the sweeper.Work methodically up and down the area to be swept, ensuring that each'pass' overlaps the previous one. To ensure the efficiency of the brushes,push the sweeper at a good, even pace. To capture larger pieces of debristhe basic clearance of the sweeper can be raised a further 20mm by rotatingthe height adjuster seen in fig.1 clockwise. Check the hopper regularly bylifting it out. Empty it if required. Place it back into the sweeper as shown infig.2. Periodically, clean the exterior of the sweeper with a damp cloth.3. ASSEMBLY & USE Ensure that the sweeper is only used on hard/dry surfaces. Ensure that the dirt collection hopper is present and properlyseated before commencing sweeping. The sweeper is for indoor use only. Do not leave the sweeper unattended, where it could become ahazard to other people or traffic in the sweeping area. Forexample, in a warehouse situation. Do not allow anyone to ride on the sweeper. Do not use the sweeper for any purpose other than that forwhich it was designed. Do not use the sweeper to clear up hazardous materials or anymaterial that may attack the plastic chassis of the sweeper. Do not use the sweeper on wet surfaces.Suitable for maintaining any hard floor and ideal for removing dirt,dust and debris from large surface areas. Features 4-brush systemwith two side brushes and two further brushes set underneath the unitto easily lift debris into the hopper. Fitted with tubular handle andadjustable castor wheel that raises the sweeper 20mm enablinglarger pieces of debris to be swept up.Model No. ................................................................................ FSW80Operating Width ....................................................................... 800mmHopper capacity ............................................................................ 40ltrfig.1fig.2

/ 2

Related manuals for Sealey FSW80