Sealey ES601 Instructions Manual

ENGINE SUPPORT BEAM WITHCROSS BEAMModel no: ES601Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAfETy9 ensure that the engine support is in good working order. Take action for immediate repair or replacement of damaged parts. Usegenuine parts only. The use of unauthorised parts may be dangerous and will invalidate the warranty.9 locate the vehicle in a suitable, well lit work area.9 Keep work area clean and tidy and free from unrelated materials.9 ensure the vehicle handbrake is engaged and the engine/motor is switched off.9 ensure all non-essential persons keep a safe distance whilst the engine support is in use.8 DO NOT use the engine support if damaged.8 DO NOT allow untrained persons to operate the engine support.8 DO NOT use the engine support for purposes other than that for which it is designed.8 DO NOT exceed the rated capacity of the engine support.9 When not in use, store engine support in a safe, dry, childproof area. WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situationsthat may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but mustbe applied by the operator.2. INTRODUCTIONdesigned to support and accurately position engines during maintenance operations such as replacing anti-vibration mountings andcertain body panels. Also used as an aid for the removal of gearboxes and transmissions. Beams supported on rubber feet and fineadjustment control is obtained by using screw/hook mechanisms. This model has the additional advantage of a 360° adjustablerotating cross beam to enable greater range of support options when in use.3. SPECIfICATIONModel no: ................................................................... eS601Maximum Capacity:...................................................... 500kgMain Beam Maximum Width .................................... 1400mmMain Beam Minimum Width: ...................................... 140mmCross Beam Maximum Width: .................................... 810mmCross Beam Minimum Width: ..................................... 140mmScrew Hook lengths: .......................................... 410/320mm4. CONTENTSeS601 Issue 2 (HF) 21/08/18Original Language Version© Jack Sealey limitedRefer toinstructionsfig.1Wear protectiveglovesWear safetyfootwearWear protectiveclothing

/ 2

Related manuals for Sealey ES601