Sealey ELECTROSTART E/START800HY Instructions Manual

instructions forELECTROSTART® BATTERYLESS POWER START800A 12Vmodel no: E/START800HYThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETYModern vehicles contain extensive electronic systems.You are required to check with the vehicle Manufacturer, for any specific instructions regarding the use of this type ofequipment on each vehicle. No liability will be accepted for damage / injury, where this product is not used in accordancewith all instructions.9 ensure that the vehicle is in a well ventilated area.9 Apply the handbrake and select neutral or ‘park’ before attempting to start.9 ensure that the ignition switch and all ancillary electrical equipment is switched off.9 Keep clear of any pulleys, belts etc. that will move once the engine starts.9 take care to ensure correct connection polarity; red clamp to positive, black clamp to negative.9 energise the e/stArt800HY only at ambient temperatures between -30°c and 40°c.9 When not in use, switch off and store in a cool, dry place out of the reach of children.8 DO NOT allow this power pack to become wet.8 DO NOT dismantle this e/stArt800HY: there are no user serviceable parts inside.8 DO NOT use in explosive atmospheres (e.g. the presence of flammable liquids, gases or dust).8 DO NOT use the e/stArt800HY if it appears damaged in any way.8 DO NOT use this product for any purpose other than that for which it is designed.8 DO NOT leave in direct sunlight or expose to heat.8 DO NOT use abrasive or solvent cleaners on this product.8 DO NOT allow children to play with this product8 DO NOT allow the positive and negative clamps to touch.1.1. BATTERY SAFETY WARNING! To reduce the risk of burns or fire:8 DO NOT attempt to open, disassemble, modify or service the battery pack.8 DO NOT crush, puncture, short external contacts or dispose of in fire or water.8 DO NOT expose to temperatures above 60°c (140°).9 replace only with the battery pack designated for this product.9 recycle or dispose of used battery as stipulated by local regulation.8 if the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with coolwater and seek immediate medical attention.2. INTRODuCTIONVehicle jump starting made easy with innovative patented technology. unlike traditional boosters it does not require an internal battery as aprimary power source but incorporates a lithium battery pack to energise the capacitors when vehicle battery is not sufficient. Simply connect tothe vehicle’s battery, even if discharged and the unit will draw enough power to energise itself in a matter of minutes. Power can then be pushedsafely back through the starting system to jump start the vehicle. if the vehicle battery is faulty or is holding less than 5 volts the e/stArt800HYcan be pre-charged via an internal lithium battery pack, another vehicle’s battery, a micro usB charging cable (not supplied) or 12V accessorylead. the digital display indicates battery voltage, capacitor charge and faults. the internal battery can hold its charge whilst not in use andwithout a battery to charge the device is ready to use in a matter of minutes. compact and lightweight for easier handling and storage, yet stilldelivers the same result as heavy, lead acid battery equivalents. ideal for both professional mechanics and diY users.3. SPECIFICATIONmodel no: ......................................................e/stArt800HYoutput: .............................................................................12Voutput start peak (en): ...................................... 800A (400A)maximum starting capacity: .................... petrol 3ltr, diesel 2ltrcable & clamp length: ................................................ 500mmsize (W x d x H):.......................................130 x 50 x 195mmlithium Battery: ................................................ 7.4V, 4400mAusB output: ................................................................. 5V 2Ae/stArt800HY | issue:2 21/07/17Original Language Version© Jack sealey limitedrefer toinstructionmanualWarning!:explosive risk Wear eyeprotection Wear protectivegloves Warning!:electricity

/ 3

Related manuals for Sealey ELECTROSTART E/START800HY