Sealey D440T Manual
400L/50L PORTABLE COMBI FUEL TANKMODEL NO: D440TThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY WARNING! This tank must ONLY be used for diesel fuel and AdBlue®.9 Place the tank on a flat surface before filling.9 Secure the tank to strong points with ratchet straps before transporting in or on a vehicle.9 Maintain the pump in good condition (use an authorised service agent).9 Replace or repair damaged parts. Use recommended parts only. Non authorised parts may be dangerous and will invalidate thewarranty.9 Keep the pump clean for best and safest performance.9 Ensure the power supply (vehicle battery) corresponds with the requirements of the pump (12V DC).9 Disconnect from battery when not in use.9 Wear protective gloves, and protective clothing when working around fuel. A full range of personal safety equipment is available fromyour local Sealey Stockist.9 Keep children and unauthorised persons away from the working area.8 DO NOT place the tank near any heat source.8 DO NOT start or stop the pump by connecting or disconnecting the battery clamps.8 DO NOT allow the unit to get wet.8 DO NOT operate the pump with wet hands.8 DO NOT use the pump where explosive or flammable vapours may be present.8 DO NOT tamper with the pump connections.2. INTRODUCTIONManufactured from hard-wearing and durable polyethylene. Main 400L capacity tank suitable for diesel, supplied with a 12V, 40L/min pump kitand automatic shut-off nozzle. A removable 50L tank for AdBlue®, supplied with a 12V, 17L/min pump kit and manual nozzle. Includes 2 x 4mdelivery hoses, 2 x dispenser nozzle holders, 2 x 4m of cable and clamps to connect to a battery. Covered by a lockable lid. Not suitable forpetrol. Complies to ADR 1.1.3.1.C for exemption from requirements of ADR regulations.3. SPECIFICATIONMODEL NO: ............................................................... D440TCapacity: ....................................... Diesel 400L/AdBlue® 50LCurrent: ..................... Diesel Pump; 15A, AdBlue Pump®; 6AFlow Rate: ....................... Diesel; 40L/min, AdBlue®; 17L/minPower:.................................... Diesel; 180W, AdBlue®; 120WSize (W x D x H): .................................. 1150 x 800 x 860mmVoltage: ............................................................................12V4. OPERATION4.1. TRANSPORT4.1.1. Move the empty tank assembly with two persons using thehand holds moulded into the base of the unit (fig.1.1).4.1.2. Move with a forklift truck using the fork locations shown in(fig.1.2). Ensure that the filler (fig.2.4) is closed beforemoving.4.1.3. Secure the tank to the carrying vehicle by ratchet straps.Locations for the straps are moulded into the tank. (fig.1.3).4.2. FILLING8 DO NOT run the pump without fuel in the tank. To do so willdamage the pump’s internal components and will void yourwarranty.4.2.1. The tank is filled by unscrewing the filler (fig.2.4) in andanticlockwise direction. Refit the filler cap immediately after filling. WARNING! Take care not to overfill the tank.fig.1D440T Issue 1 14/06/2021Original Language Version© Jack Sealey LimitedRefer toinstructionsWear eyeprotectionWear protectiveglovesWear safetyfootwearWear protectiveclothing |
Related manuals for Sealey D440T
This manual is suitable for:
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved