Sealey CST980.V2 Quick Start Manual

90KG FOLDING SACK TRUCKMODEL NO: CST980.V2Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.1. SAFETY9 Always load evenly with the centre of gravity of the load as near the centre of the truck as possible.9 Obtain additional support for large or wide loads to prevent tipping.8 DO NOT overload the truck - see Specifications.8 DO NOT leave unattended, especially when loaded, unless the wheels are chocked or the truck is otherwise secured.8 DO NOT use truck on uneven ground and do not run over curbs or steps - use a ramp.8 DO NOT allow others to ride on the truck.8 DO NOT use the truck if any part is significantly damaged - pay particular attention to the wheels.2. INTRODUCTIONLightweight aluminium frame, weighs only 7kg yet has a carrying capacity of 90kg. Folding steel foot plate and telescopic handle with springrelease means that trolley can be packed away in seconds. Large back support makes light work of oversized loads. Fitted with Ø150mm wheelsfor easy-rolling over rough ground. Ideal for business and home use.3. SPECIFICATIONModel no ..............................................................CST980.V2Height(s) ........................................................... 710-1080mmOverall width .............................................................. 395mmPlatform depth............................................................ 240mmWheel depth ............................................................ Ø150mm4. INTRODUCTIONLightweight aluminium frame, weighs only 7kg yet has a carrying capacity of 90kg. Folding steelfoot plate and telescopic handle with spring release means that trolley can be packed away inseconds. Large back support makes light work of oversized loads. Fitted with Ø150mm wheelsfor easy-rolling over rough ground. Ideal for business and home use.5. ASSEMBLY5.1. Make sure the axle is clean from dust and dirt to allow free movement of the wheel.5.2. Place the sleeve (fig.1.2) onto the axle (fig.1.1), as far as it will go.5.3. Slide the wheel (fig.1.3) onto the axle, and complete by pushing the pin (fig.1.4) throughthe hole in the end of the axle.5.4. Repeat the operation for the other side.6. OPERATION6.1. Firstly fold down the foot plate ready to accept a load (fig.2).6.2. To extend the handle push the spring loaded locking bar forward (fig.2A) and lift thehandle upwards until it latches in its fully extended position.6.3. To lower the handle, push the spring loaded locking bar forward and push the handledownwards until it latches in the closed position.6.4. After use close the handle, fold up the foot plate and store in a safe dry place.6.5. Only use truck with handle fully closed or fully extended.Refer toinstructionmanualOriginal Language Version© Jack Sealey Limitedfig.1fig.2CST980.V2 Issue:2 (HF) 21/01/21

/ 2

Related manuals for Sealey CST980.V2