Sealey CP40MC Instructions Manual

1.1 ELECTRICAL SAFETY.REGARDING DIRECT MAINS POWER USE WITH THECHARGING BASE AND PLUG ONLY. WARNING! It is the owner’s responsibility to read, understandand comply with the following electrical instructions:You must ensure the risk of electric shock is minimised by theinstallation of appropriate safety devices. An RCCB (ResidualCurrent Circuit Breaker) should be incorporated in the maindistribution board. We also recommend that an RCD (ResidualCurrent Device) is used with all electrical products, particularlyportable equipment which is plugged into an electrical supplynot protected by an RCCB.You must also read and understandthe following instructions concerning electrical safety.The Electricity At Work Act 1989 requires all portable•electrical appliances, if used on business premises, to betested by a qualified electrician, using a PortableAppliance Tester (PAT), at least once a year.The• Health & Safety at Work Act 1974 makes owners ofelectrical appliances responsible for the safe condition of theappliance, and the safety of the appliance operator. If in anydoubt about electrical safety, contact a qualified electricianBattery Charger Safety Instructions• WARNING! DO NOT use the charging base to charge anybattery other than that required for the tool. Other types ofbatteries may explode! Inspect the plug, cable and the charging base for wearand damage to ensure items are safe before connecting to themains power supply. If worn or damaged DO NOT use,immediately replace, or contact a qualified electrician. Check cables are always protected against short circuit andoverload. Uncoil the power cable between the plug and the charging basebefore use. DO NOT pull or carry the charging base by the charger powerlead, or pull the plug from the mains socket by the power lead. DO NOT use any other type of transformer with the charging base. DO NOT try to open or dis-assemble the plug or charging base. DO NOT use the plug to power any other electrical item. Disconnect the plug from the charging base and the mainspower supply when not in use. DO NOT expose the charging base to damp or wet conditions(for indoor use only). DO NOT pull or carry the charging base by the power lead. DO NOT operate the charging base if it has been dropped, orhas received a sharp knock, or is damaged. Contact anauthorised service agent. DO NOT dismantle the charging base as this may causedamage or personal injury and will invalidate your warranty. DO NOT insert foreign objects or material into the holereserved for the battery. DO NOT immediately charge a second battery. Consecutivecharging will overheat the charging base. Allow the unit to coolfor 15 minutes before charging the next battery. Ensure that the insulation on all cables and on the appliance issafe before connecting it to the power supply. Ensure that cables are always protected against short circuitand overload. DO NOT use worn or damaged cables, plugs or connectors.Immediately have any faulty item repaired or replaced by aqualified electrician.When a BS1363/A UK 3 pinplug is damaged, cut the cablejust above the plug and disposeof the plug safely.Fit a new plug according to thefollowing instructions (UK only).a) Connect the GREEN/YELLOW earth wire to theearth terminal ‘E’.b) Connect the BROWN livewire to the live terminal ‘L’.c) Connect the BLUE neutral wire to the neutral terminal ‘N’.d) After wiring, check that there are no bare wires, that allwires have been correctly connected, that the cable outerinsulation extends beyond the cable restraint and that therestraint is tight. Double insulated products, which are alwaysmarked with this symbol ,are fitted with live (brown) andneutral (blue) wires only. DO NOT connect either wire to the earth terminal.1.2 BATTERY SAFETY INSTRuCTIONS. WARNING! Battery contains lithium-ion which is dangerous.Handle with care to avoid damage, fire, corrosion or personalinjury. Charge battery prior to its first use. The battery will havebeen shipped in a low charge state.To reduce the risk of burns or fire: DO NOT Attempt to open, disassemble, modify or service thebattery pack. DO NOT Crush, puncture, short external contacts or dispose ofin fire or water. DO NOT Expose to temperatures above 40°C (104°). Replace only with the battery pack designated for this product. Recycle or dispose of used battery as stipulated by localregulation. Use only the charging base provided to charge the chargerbattery. DO NOT attempt recharging the battery by means of an enginegenerator or a DC power source. WARNING! Dispose of spent batteries correctly as they containLithium-ion. DANGER! DO NOT attempt to disassemble thebattery. For safety and environmental reasons DO NOT discardin domestic waste or by burning. ONLY discard or recycleaccording to local authority regulations. WARNING! DO NOT allow a leaking battery to contact yourperson. If you come into contact with battery liquid take thefollowing immediate action: a) Skin contact: Wash immediately with soap and water,then wash flesh in either lemon juice or vinegar. b) Eye contact: Wash with a strong solution of boric acid,and seek immediate medical attention.1. SAFETY INSTRuCTIONSCP40MC Issue: 1 - 06/07/09INSTRUCTIONS FOR:LITHIuM-ION 12V MAINSCHARGER - 1 HOuRMODEL No: CP40MCThank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properlymaintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRuCTIONS CAREFuLLY. NOTE THE SAFE OPERATIONAL REQuIREMENTS, WARNINGS, ANDCAuTIONS. uSE THIS PRODuCT CORRECTLY, AND WITH CARE FOR THE PuRPOSE FOR WHICH IT IS INTENDED. FAILuRE TO DO SO MAYCAuSE DAMAGE AND/OR PERSONAL INJuRY AND WILL INVALIDATE THE WARRANTY.FuSE RATING5 AMPBlueNeutralWireYellow & GreenEarth WireCableRestraint

/ 2

Related manuals for Sealey 5051747459977