Sealey CP20VTP Manual

CORDLESS 20V TELESCOPIC POLE FORCP20VPSH/CP20VPHTMODEL NO: CP20VTPThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY1.1. BATTERY SAFETY INSTRUCTIONS (BATTERY NOT INCLUDED) WARNING! Battery contains Lithium-ion which is dangerous. Handle with care to avoid damage, fire, corrosion or personal injury.9 Charge battery prior to its first use. The battery will have been shipped in a low charge state. To reduce the risk of burns or fire:8 DO NOT attempt to open, disassemble, modify or service the battery pack.8 DO NOT crush, puncture, short external contacts or dispose of in fire or water.8 DO NOT expose to temperatures above 40°C (104°F).9 Replace only with the battery pack designated for this product.9 Use only the charging base provided to charge the tool.9 Remove the battery if the tool is not to be used for a period of time.9 Keep the battery terminals and grooves free from wood chips, sawdust or soil.8 DO NOT allow the battery to become fully discharged.9 Recharge the battery when you notice the tool has less power.8 DO NOT recharge a fully charged battery. Overcharging shortens the batteries service life.9 Charge the battery at a room temperature between 5ºC to 45ºC.9 Charge the battery if tool has not been used for 6 months.8 DO NOT attempt recharging the battery by means of an engine generator or a DC power source. WARNING! Dispose of spent batteries correctly as they contain Lithium-ion. DANGER! DO NOT attempt to disassemble thebattery. For safety and environmental reasons DO NOT discard in domestic waste or by burning. ONLY discard or recycle accordingto local authority regulations. WARNING! DO NOT allow a leaking battery to contact your person.1.2. GENERAL SAFETY WARNING! Ensure that Health & Safety, local authorityand general workshop practice regulations are adhered towhen using this equipment.9 Familiarise yourself with the applications, limitations andpotential hazards peculiar to the tool. WARNING! Disconnect the battery before changingaccessories, servicing or performing any maintenance.9 Maintain the tool in good condition (use an authorisedservice agent).9 Replace or repair damaged parts. Use genuine parts only.Unauthorised parts may be dangerous and will invalidatethe warranty.9 Keep the work area clean, uncluttered and ensure thatthere is adequate lighting.9 Keep the tool clean for best and safest performance.9 Maintain correct balance and footing. Ensure the floor isnot slippery and wear non-slip shoes.9 Remove ill fitting clothing. Remove ties, watches, rings andother loose jewellery and contain, and/or tie back, long hair.9 Keep children and unauthorised persons away from thework area.9 DO NOT use the tool for any purpose other than that forwhich it is designed.8 DO NOT operate the tool if any parts are damaged ormissing.8 DO NOT get the tool wet or use in damp or wet locations orareas where there is condensation.8 DO NOT allow untrained persons to operate the tool.8 DO NOT operate tool when you are tired or under theinfluence of alcohol, drugs or intoxicating medication.CP20VTP Issue 1 25/10/21Original Language Version© Jack Sealey LimitedRefer toinstructionsCP20VPSH (sold separately)CP20VPHT (sold separately)CP20VTP

/ 4

Related manuals for Sealey CP20VTP