Sealey CP20VCP Manual

USB CHARGE PORT FOR SV20 SERIESMODEL NO: CP20VCPThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY9 Inspect the unit for wear and damage to ensure the item is safe before connecting to the battery. If worn or damaged DO NOT use.8 DO NOT use the unit in damp conditions.8 DO NOT shine directly into your, another person’s or an animal’s eyes.8 DO NOT allow children to use the unit.8 DO NOT use the unit if you suspect that the battery or the unit casing is damaged.8 DO NOT leave batteries in a discharged state, recharge batteries immediately. Before storage, fully recharge the battery,subsequently recharge the battery at least once every six months of non-use.8 DO NOT attempt to open, disassemble, modify or service the unit.8 DO NOT crush, puncture, short external contacts or dispose of in fire or water.8 DO NOT expose to temperatures above 60°C (140°).9 Recycle or dispose of unit as stipulated by local regulation.2. INTRODUCTIONSlides onto Sealey 20V batteries to provide a 5V USB charging output for mobile devices. Built-in 30 Lumen LED light controlled by on/offswitch. Fitted with belt hook for charging on the go.3. SPECIFICATIONMODEL No.: ..........................................................CP20VCPApplications: ..................CP20VBP2, CP20VBP, CP20VBP4Battery: ...........................20V 2Ah - 4Ah Li-ion (not included)Input: ............................................................................... 20VLED Light ....................................................................... 30lmOutput: .......................................................................5V 1.5A4. OPERATION4.1. 5V CHARGING (fig.1, fig.3)4.1.1. Press On/Off switch (fig.1) to use 5V charging socket (fig.3). When socket is available for use the On/Off LED (fig.1) is lit.4.2. LED HEADLIGHT (fig.2)4.2.1. Press LED light switch to illuminate the LED headlight. Press again to switch LED off.5. MAINTENANCE5.1. To clean unit, use only a lightly damped, clean cloth. DO NOT allow the unit to get wet.CP20VCP Issue 2 (2) 12/06/20Original Language Version© Jack Sealey LimitedRefer toinstructionsfig.3fig.2fig.1Keep away fromrain and moisture

/ 2

Related manuals for Sealey CP20VCP