Sealey Benchclaw SBC01 Instructions Manual

T H E N E W W A Y T O M O U N T Y O U R B E N C H T O O L STMBenchclawmodel no: SBc01Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMpORTanT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SafeTy waRnInG! only use Benchclaw for its intended purpose. waRnInG! Two people may be required to fit heavier tools to the workbench. Check working capacity of workbench plus tool andworkpiece. waRnInG! ensure the power supply is switched off when fitting Benchclaw to a tool.9 Always use all 4 bolts and washers supplied when attaching Benchclaw to your specified tool.9 ensure the power supply is switched off when the tool is not in use.8 DO nOT leave workbench unattended, unless in a secure, locked location.2. InTRODucTIOnPatented design enables power tools fitted with Benchclaw to be quickly and easily mounted to conventional workbenches with a maximumsurface thickness of 20mm. Suitable for a variety of tools including mitre saws and bench grinders with mounting hole centres between 100mmto 375mm. Foldaway claws auto-retract enabling use on ground or flat work surfaces without needing to disconnect Benchclaw from your chosentool.3. SpecIfIcaTIOnModel no: ...................................................................SBc01Required Workbench Jaw opening: ............................ 100mmmax. surface thickness ................................................. 20mmnett Weight: ................................................................ 1.34kg4. aTTachMenT TO pOweR TOOlS4.1. To avoid any misalignment between both Benchclaw brackets on installation, attach the Benchclaw to your power tools in thefollowing way:4.1.1. Position both Benchclaw brackets on the opened workbench.4.1.2. Close the workbench vice onto the Benchclaw hooks, without fully tightening.4.1.3. Slide the securing nuts to each end of the Benchclaw bracket.4.1.4. lower the power tool onto the Benchclaw brackets and check correct alignment.4.1.5. Fully tighten the workbench vice.4.1.6. Attach Benchclaw to power tools using the 4 bolts, washers and split washers supplied.5. OpeRaTIOn5.1. Open jaws on workbench wide enough to allow the power tool with Benchclaw attached, to rest on workbench, see fig.1.5.2. Close the Workbench vice onto the Benchclaw hooks, until tight, fig.2.5.3. Place the power tool in a central, well balanced position for maximum stability, fig.3.5.4. Remove from workbench and fold ‘claws’ away to use Benchclaw on a flat surface, see fig.4,nOTe: Carry out a Risk Assessment for the operation of each power tool attached to a Benchclaw, before use.SBC01 | Issue 2 (4,5) 15/04/19Original Language Version© Jack Sealey limitedRefer toinstructionsfig.1 fig.3fig.2

/ 2

Related manuals for Sealey 5054511591026