Sealey BTR4.V2 Instructions Manual

Robust trolley carries portable MIG welder and gas bottle, makingrelocation of welding equipment quick and easy. Fitted with two fixedwheels and two castors for excellent manoeuvrability and suppliedwith bottle retaining chains and cable stowage hooks.Upper tray for MIG welder and two lower trays for associated items.Suitable for portable MIG welders up to 300mm wide and 480mmlong.Suitable for Sealey Welders: PMG110 and S0771. Also PM140XT,PM150XT, PMG135XT, PMG155XT with wheels and axle removed. DO NOT put more than one bottle on the trolley. Always seat the bottle in the upright position. Always secure the bottle tightly to the trolley with the chainsprovided. Only use the trolley on firm, level, unobstructed surfaces whichare capable of supporting the trolley and its load. DO NOT use the trolley on sloping surfaces. DO NOT allow others to ride on the trolley. DO NOT attempt to move the trolley by pulling on the earth ortorch cable. DO NOT attach the welder’s earth clamp to the metal frame ofthe trolley as this may result in accidental arcing from the torch. Replace or repair damaged parts. Use only recommendedparts. Unauthorised parts may be dangerous and will invalidate thewarranty. Store gas cylinders in a vertical position only and ensure thestorage area is correctly secured. DO NOT store gas cylinders in areas where temperatureexceeds 50°C. DO NOT use direct heat on a cylinder. Alwayskeep gas cylinders cool. DO NOT attempt to repair or modify any part of a gas cylinderor valve, and DO NOT puncture or damage a cylinder. DO NOT obscure or remove any official labels from a cylinder.Always check the gas identity before use. Avoid getting gas cylinders oily or greasy. DO NOT try to lift or handle cylinder by its cap, guard or valve.Always keep caps and guards in place and close valve whennot in use.Gas cylinders are heavy, use mechanical lifting equipment. Warning! Failure to comply with these instructions may result in lossof load, damage to trolley or other property and/or personal injury.No. Description Qty.1 Top Tray 12 Hook 23 Middle Tray 14 Left support 15 Bottom Tray 16 Front Castor Wheel 27 Hex-nut 348 Right Support 19 Hex-bolt 3410 Split Pin 211 Flat Washer 412 Rear Wheel 213 Axle Support 214 Axle 115 Back Panel 116 Chain 23.1 Using the diagram below as a guide; loosely assemble thetrolley.3.2 Slide the axle supports (13) through the slots in the base (5)so the axle may be inserted into the supports.3.3 When the wheels (12 and 6), back panel (15), shelves (1, 3and 5), upright supports (4 and 8) and the hooks (2) are inplace, tighten all fixings.NOTE! When attaching the back panel (15) ensure the slots for thechains are facing downwards.UNIVERSAL TROLLEY FOR PORTABLE MIGWELDERSMODEL NO: BTR4.V21. SAFETY2. INTRODUCTION3. ASSEMBLYIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCTCORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILLINVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions and maintained properly, give you years of trouble free performance.Refer to instructionmanualBTR4.V2 Issue:3(HF)- 22/03/18© Jack Sealey Limited Original Language Version

/ 2

Related manuals for Sealey BTR4.V2