Sealey Autocharge10s Instructions Manual

instructions forauto maintenance high frequencybattery charger 6/12V 10amPmodel no: autocharge10sthank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. safety1.1. electrical safety Warning! it is the user’s responsibility to check the following:check all electrical equipment and appliances to ensure that they are safe before using. inspect power supply leads, plugs andall electrical connections for wear and damage. sealey recommend that an rcd (residual current device) is used with all electricalproducts. You may obtain an rcd by contacting your local sealey dealer.if used in the course of business duties, it must be maintained in a safe condition and routinely PAt (Portable Appliance test) tested.electrical safety information, it is important that the following information is read and understood.9 ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.9 regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.9 Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correct fuse - seefuse rating in these instructions.8 Do not pull or carry the appliance by the power cable.8 Do not pull the plug from the socket by the cable.8 Do not use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or replaced immediately by aqualified electrician.9 This product is fitted with a BS1363/A 13 Amp 3 pin plug.if the cable or plug is damaged during use, switch off the electricity supply and remove from use.Ensure that repairs are carried out by a qualified electrician.Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.b) Connect the BROWN live wire to the live terminal ‘L’.c) Connect the BLUE neutral wire to the neutral terminal ‘N’.ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.Sealey recommend that repairs are carried out by a qualified electrician.▲ Danger! be aWare, LeaD-aciD batteries generate eXPLosiVe gases DuringnormaL battery oPeration. for this reason, it Very imPortant to reaD anD foLLoWthese instructions carefuLLy, each time you use the charging equiPment.follow these instructions and those published by the battery and vehicle manufacturers, and the maker of any equipment you intend touse in the vicinity of the battery. remember to review warning marks on all products and on engines. Warning! modern vehicles contain extensive electronic systems.You are required to check with the vehicle Manufacturer, for any specific instructions regarding the use of this type of equipment oneach vehicle.No liability will be accepted for damage / injury, where this product is not used in accordance with all instructions.1.2. Personal Precautions9 ensure there is another person within hearing range of your voice and close enough to come to your aid,should a problem arise when working near a lead-acid battery.9 Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery.9 Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.9 Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, cleanrunning water for at least 15 minutes and seek immediate medical attention.recommended fuse rating3 AmpAUTOCHARGE10S | Issue 1 21/12/16Original Language Version© Jack sealey limitedrefer toinstructionselectricalshockhazardWear eyeprotectionWear protectiveglovesWarningcorrosivesubstanceWarning:explosivematerialKeep awayfrom sources ofignitionuse in wellventilated areasKeep in dry areaprotect from rain

/ 3

Related manuals for Sealey Autocharge10s