6 DRAWER TOPCHEST & ROLLCABCOMBINATION WITH BALL-BEARING SLIDESMODEL NO: AP22 SERIESThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this Topchest& Rollcab combination.9 Locate the Topchest & Rollcab combination in a suitable working area.9 Keep the work area clean, uncluttered and ensure there is adequate lighting.9 Keep the Topchest & Rollcab combination clean and tidy in accordance with good workshop practice.9 Keep children and unauthorised persons away from the working area.8 DO NOT use the Topchest & Rollcab combination for any purpose other than that for which it is designed.8 DO NOT move the Topchest & Rollcab combination with drawers open.8 DO NOT open more than one drawer at the same time.8 DO NOT step on the drawers.8 DO NOT use in damp work areas. WARNING! The warnings, cautions and instructions referred to in this instruction manual cannot cover all possible conditions and situations thatmay occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by theoperator.2. INTRODUCTIONThe economical way to buy American PRO® Ball-Bearing quality tool chests. Supplied packed one inside the other. This mid-size combo hassmooth 25mm ball-bearing slides and all the features of the professional chests, except that the rollcab is not lockable and the castors areØ75mm. These boxes are not interchangeable with the rest of the American PRO® Ball-Bearing Range.3. SPECIFICATIONModel No: .......................................................... AP22 SeriesW x D x H:4 Drawer Topchest:Overall size: ............................................612 x 260 x 340mmSmall Drawer (x3): ....................................510 x 225 x 35mmMedium Drawer (x1):.................................510 x 225 x 85mm2 Drawer Rollcab:Overall size: ............................................615 x 295 x 705mmMedium Drawer (x2):.................................515 x 275 x 65mmCupboard (x1): ........................................610 x 275 x 375mm4. ASSEMBLYRefer toinstructionmanualAP22 Series Issue:1 10/01/22Original Language Version© Jack Sealey Limitedfig.1 fig.2