instructions for:double lever grease gunmodel no: aK4403Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. safeTy WarnIng! ensure Health & safety, local authority and general workshop practice regulations are adhered to when using this equipment.9 familiarise yourself with the application and the limitations of the grease gun, as well as the potential hazards.9 Keep the work area clean, uncluttered and ensure there is adequate lighting.9 Keep the grease gun clean for best and safest performance.9 check moving parts alignment on a regular basis.8 do noT use the grease gun for any purpose other than that it was designed for.8 do noT operate the grease gun if any parts are damaged or missing, as this may cause failure and/or personal injury.9 When not in use store in a safe, dry, childproof location. WarnIng! Always wear approved eye protection when operating this gun.2. InTroducTIonrobust, double arm grease gun with aluminium die-cast head. uses screw type grease cartridges using vacuum suction to ensure full utilizationof grease cartridge as well as eliminating priming issues associated with conventional grease guns. features a protective cap for hose storagepreventing contamination. 1/8” BSPT thread and supplied with adaptor to fit most screw type cartridges on the market, including model numbers:scs107 & scs108. Zinc plated lever handles with rubber ergonomic grips. fitted with minimal wearing parts to ensure prolonged life andsupplied with 300mm (12”) delivery hose and 4-jaw coupler.3. specIfIcaTIonModel no: ................................................................. aK4403delivery pressure: ......................................................7500psidelivery per stroke: ..................................................... 0.8cm²4. operaTIon4.1. remove cap from cartridge and screw into grease gun body, (select grease gun cartridge adaptor as appropriate).4.2. Work handles to displace air from delivery tube.AK4403 | issue 1 01/02/16Original Language Version© Jack sealey limitedrefer toinstructionmanualWear eyeprotection