Sealey ACL3.V3 Instructions Manual

Also see for 5051747384972: Instructions

INSTRUCTIONS FOR:TRADE COMBINATION LADDERS3-SECTIONModel No's: ACL3.V3, ACL307, ACL312.V2Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.1. SAFETY / uSAgE INSTRuCTIONSIMPORTANT: PLEASE READ THESE INSTRuCTIONS CAREFuLLY. NOTE THE SAFE OPERATIONAL REQuIREMENTS, WARNINgS & CAuTIONS.uSE THE PRODuCT CORRECTLY AND WITH CARE FOR THE PuRPOSE FOR WHICH IT IS INTENDED. FAILuRE TO DO SO MAY CAuSEDAMAgE OR PERSONAL INJuRY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRuCTIONS SAFE FOR FuTuRE uSE.2. INTRODuCTION2.1 IntroductionMulti-use aluminium extension ladders manufactured to EN131 standards. Ideal for the tradesman, these ladders can be used as a3-section or 2-section extension and as a single ladder, which is ideal for two-man use. Can be used as a step and extension stepladder where stability and height are needed. Compact size for easy handling and storage. Two larger models suitable to extend up tothe apex of a house.Before use:a) Check your physical fitness before using a ladder.Certain pathologies or medicines, overindulgence in alcohol orconsumption of drugs can represent a danger.b) When transporting a ladder on the roof rack of your vehicle orin a lorry, make sure that it is secured firmly to avoid causing anydamage.c) Before using the ladder for the first time, check it to ensurethat all its parts are in good condition and operate correctly.d) Before use, check the ladder visually to ensure that it has notbeen damaged and can be used in complete safety.e) Regular checks are essential for all users.f) Check that the ladder is suitable for the job to be done.g) Do not use a damaged ladder.h) Clean the ladder of any foreign substances such as wet paint,mud, oil or snow.i) Before using the ladder for professional purposes, risks mustbe assessed depending on the legislation of the country in use.Positioning and Erecting Ladders:a) Ladders must be put up in the right position, i.e. at the correctangle (inclined at about 1 in 4), with the steps or rungs parallelfor a leaning ladder, or completely open in the case of a trestleladder.b) Any ladder equipped with locking systems; the locks must be inthe fully locked position.c) Ladders must be placed on flat regular and firm surface.d) Leaning ladders must always be placed on a flat solid surfaceand be stabilized before use, for example by using ties or anyother suitable device for ensuring their stability.e) Ladders must never be repositioned from a point high-up.f) When installing a ladder take account of any possible risks ofcollision, e.g. collisions with pedestrians, vehicles or doors.If possible, secure any doors (other than emergency exits) andwindows on the site.g) Identify all electrical risks on the work-site, e.g. overhead lines orany other bare electrical equipment.h) Ladders must rest firmly on their treads and not be on rungs orsteps.i) Ladders must not be placed on any slippery surfaces (e.g. ice,shiny surfaces or surfaces clearly covered with foreignsubstances) unless other effective means have been taken toavoid the ladder slipping. Otherwise, make sure that all dirty orcontaminated support surfaces have been adequately cleaned.Using the Ladder:a) Do not exceed the maximum load allowed for the type of ladder.b) Do not try to reach a point too far away from you; your waistshould always be between the ladder’s two uprights and yourfeet on the same step or rung whilst working.c) Do not climb down a high leaning ladder without using an extrasafety system (for example, a tie or use of a suitable stabilizingdevice).d) Do not use a trestle ladder to get up to a higher level.e) Do not stand on the top three steps or rungs of a leaning ladder.f) Do not stand on the top two steps or rungs of a trestle ladderwhere there is no platform or support at hand or knee height.g) Do not stand on the top four steps or rungs of a trestle ladderwith an extension ladder on top.h) Ladders should only be used for minor, short-duration jobs.i) Use non-conductive ladders when working on jobs whereelectrical power is present.j) Do not use ladders outside in unfavorable weather conditions(high winds for example).k) Take all necessary precautions to prevent children from playingon ladders.l) If possible, secure any doors other than emergency exits andwindows on the site.m) Climb up and come down a ladder facing it.n) Hold the ladder firmly when climbing or coming down.o) Do not use ladders as bridges.p) Always wear suitable shoes for climbing ladders.q) Avoid all excessive lateral constraints such as when usinga drill in brick and concrete.r) Do not stay too long up the ladder without making regularstops (fatigue risks).s) To go up to higher levels, ladders should be extended atleast one metre above the height to be reached.t) Light-weight easy-to-handle equipment should be usedwhen on a ladder.u) Avoid works that create side loads on trestle ladders, e.g.for drilling hard materials (brick, concrete, etc.).v) Hold onto the ladder with one hand when working. If thisis not possible, other types of safety measures should betaken.Repairs and maintenance must be carried out by aqualified person in compliance with the manufacturer’sinstructions. Ladders should be stored according to themanufacturer’s instructions.Model No: ACL307 ACL3.V3 ACL312.V2Minimum Height: 1.99mtr 2.55mtr 3.39mtrMaximum Extension: 4.23mtr 5.91mtr 7.31mtrMaximum Reach: 5.13mtr 6.81mtr 8.21mtrMaximum Capacity: 150kg 150kg 150kgWeight: 9.1kg 12.5kg 17.3kgACL3.V3, ACL307, ACL312.V2 Issue: 1 - 19/12/11

/ 2

Related manuals for Sealey 5051747384972