Menu
Sealey AB931.V2 Instructions Manual
   |
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFEOPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCTCORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURETO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THEWARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used accordingto these instructions and properly maintained, give you years of trouble free performance.1. SAFETY INSTRUCTIONS WARNING! Ensure that Health and Safety, local authority and general workshop practice regulationsare adhered to when using tools. Ensure that the air brush and accessories are in a clean, sound condition and good working order. Takeaction for immediate repair or replacement of damaged parts. Use recommended parts only. The use ofunauthorised parts may be dangerous and will invalidate the warranty. Ensure the air brush supply hose is not tangled, twisted or pinched. DO NOT use air brush or accessories if damaged. DO NOT operate air brush under the influence of drugs, alcohol, intoxicating medication, or if fatigued. DO NOT direct spray against yourself, other persons or animals, electrical equipment or the machine itself. DO NOT use the air brush for a task it is not designed to perform. Wear approved eye protection and a suitable respirator when painting. A full range of personal safetyequipment is available from your Sealey Dealer. DO NOT allow smoking or open flame in the work area.3. ASSEMBLYNote: Numbers in brackets refer to item numbersin Fig. 4.3.1. Screw the gravity cup (03) into the top ofthe nozzle seat (01).3.2. Screw one end of the hose assembly (05)onto the inlet (01).3.3. Screw the other end of the hose assembly(01) to the air supply.3.4. When using a compressor (Sealey ModelNo. AB900), connect the hose assembly(05) to the air hose adaptor beforeconnecting to the compressor, fig.1.A.3.5. When using a propellant can (Sealey ModelNo. AB/P), connect the hose assembly (05)4. OPERATING INSTRUCTIONS4.1. Mask the area which is NOT to be painted.4.2. Ensure the object to be painted is free from dust, grease and the surface has been prepared.4.3. After mixing and thinning the paint, as instructed by the paint manufacturer, fill the gravity cup just overhalf full and replace the lid.Note: Mix thoroughly, making sure that the paint is free from lumps. It may be necessary to strain the paint first.4.4. Turn the air ON and test your spray on a suitable test panel to get the “feel” of your air brush.4.5. Make any necessary spray adjustments. The paint flow and spray pattern are adjusted by turning the fluidcap at the front of the air brush. The cap is completely closed when it has been turned clockwise to thestop point. To obtain various degrees of paint flow, turn the cap anti-clockwise. The maximum flow will beattained by turning the cap approximately 4 turns anti-clockwise.to the air regulator valve (02).3.6. Ensure the valve is turned fully anti-clockwise before screwing to the top of the propellant can, fig.1.B.INSTRUCTIONS FOR:AIR BRUSH KIT WITHOUTPROPELLANTMODEL N O: AB931.V2AB931.V2 Issue: 1 10/01/14Original Language Version© Jack Sealey LimitedGravity fed air brush with composite body. Suitable for blowing-in small areas of panel. Kit includes gravity cup,propellant adaptor, 1.5mtr of small bore hose, 1/4" reduction nipple. Supplied in composite case.2. INTRODUCTIONFig.1AFig.1B |
Related manuals for Sealey AB931.V2
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved