Sealey 3S/4R.V3 Quick Start Manual

METAL CUTTING SHEARSMODEL NO: 3S/4R.V3, 3S/5R.V3, 3S/6R.V3Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPPORRTATANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHHE PPROODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPEERSSONNAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY Ensure that the shears are securely mounted on a rigid work surface surrounded by sufficient free area to manipulate the workpieceeasily and safely. Always wear suitable Personal Protective Equipment to guard against injury. Protective goggles and gloves are available from yourSealey Stockist. Non slip footwear should be worn. Make sure that the work area is well lit and is kept tidy. The floor should be dry and clean. DO NOT allow fingers or hands to come into close proximity to the cutting wheels and beware of sharp edges and swarf. DO NOT use this product if tired or under the influence of alcohol or drugs. Keep children well away from this product at all times.2. INTRODUCTIONManufactured from steel-plate and fitted with hardened steel shear blades for accurate cutting and long life. Designed to be bolted to thebench. Suitable for cropping steel sheet and bar.3. SPECIFICATIONModel No:.......................................................3S/4R.V3 .................................. 3S/5R.V3................................3S/6R.V3Maximum Cut Length: ........................................ 105mm ......................................135mm................................... 175mmRound Bar: .......................................................Ø10mm* ....................................Ø11mm*................................. Ø12mm*Sheet: .................................................................. 4mm* ........................................ 5mm*......................................6mm*Note: *Capacity in Steel4. ASSEMBLY4.1. Securely bolt the body of the shear to a strong work surface at a comfortable height.4.2. Connect both parts of the handle together and attach it to the body.5. OPERATION Ensure that the shears are securely mounted on a rigid work surfacesurrounded by sufficient free area to manipulate the workpieceeasily and safely. DO NOT force this machine to cut metals beyond its specified range.5.1. CUTTING FLAT METAL5.1.1. Scribe a line on the metal to be cut.5.1.2. Line up scribe mark with jaws and pull handle.5.1.3. If required, use the adjustable support rod to stop metal fromdeforming while cutting.5.1.4. Extend the handle for the thicker metals.5.1.5. When cutting a sheet of metal, take small cuts and feed the sheetinto the jaws being careful to keep your fingers clear of the jaws.If the sheet of metal is awkward make sure you have assistance.5.2. CUTTING ROUND BAR5.2.1. Round bar can be cut using the bar cutting hole in the blade.6. MAINTENANCE6.1. Lightly oil moving components.Bar CutterAdjustableSupport Rodfig.13S/4RV3, 3S/5R.V3, 3S/6R.V3, Issue 2 (3) 09/11/21Original Language Version© Jack Sealey LimitedRefer toinstructionsWear eyeprotectionWear protectivegloves

/ 2

Related manuals for Sealey 3S/4R.V3