Menu
Sanyo choice pr 1 Installation Instructions Manual
      |
INSTALLATION INSTRUCTIONS1 CHANNEL PROGRAMMERTechnical DataPower Supply: 230V AC, 50HzOperating Temperature: 0°C to 35°CTotal Switch Rating: 230V AC, 6(2)AContact Type: 1B , Micro-Disconnection (Voltage Free)Battery Type: Lithium Cell CR2032Enclosure Protection IP30Plastics Thermoplastic, flame retardantInsulation Class DoubleWiring: For fixed wiring onlyBackplate Industry standardDimensions: 140mm x 87mm x 37mmClock 12 hour am/pm, 1 minute resolutionBST/GMT time change AutomaticClock Accuracy +/- 1 sec per dayProgram Cycle 24hr, 5/2day or 7day selectable.Program On/offs per day 2on/off, 3on/off selectableProgram Resolution 10minsProgram Selection Auto, On all day, On constant, OffProgram Override +1,2 or 3Hr, AdvanceComplies with EN60730-1, EN60730-2.7, EMC Directive 2004/108/EC,LVD Directive 2006/95/ECPre-Installation Product Set Up:Before installing, set the bank of 4 DIP Switches on the back to configure the unit accordingto the chart below:DIP Switches: Shown in Factory Default Positions.24 Hr – runs same programme every day.5/2 Day – allows different on/off times at weekend.7 day – allows different on/off times every day.Electrical ConnectionsInternal Wiring DiagramNote: The Switch is volts free. COM should be linked to L for mains switching.Fitting the ProgrammerLoosen the two ‘captive’ retaining screws on the bottom of the backplate. Now fit the programmer to the back plate, ensuring the lugs ofthe back plate engage with the slots on the programmer. Swing thebottom of the programmer into position ensuring the connection pinson the back of the unit locate into the terminal slots in the back plate.Tighten the two ‘captive’ screws to fix the unit securelyCommisioningSwitch on mains supply.Referring to the user guide1. Use the buttons to ensure correct product functionality.2. Set timing and programme details in accordance with customer requirements.3. Normally unit will be left with channel in ‘Auto’ mode.4. Leave these installation instructions with customer for reference.In the interests of continuous product improvement we reserve the right to alter designs,specifications and materials without prior notice and cannot accept liability for errors.143702_ASangamo Limited, Industrial Estate, Port Glasgow, Renfrewshire PA14 5XGTel: 01475 745131 Fax: 01475 744567Email: enquiries@sangamo.co.uk Web: www.sangamo.co.ukCHOICE PR 1SERVICE AND WARRANTYYour product is not user serviceable. PLEASE DO NOT TRY TO DISMANTLE THE UNIT.This product is guaranteed by your supplier for 3 years from the Date of Manufacture. If it should becomedefective, please contact your installer or supplier for a replacement unit or visit www.sangamo.co.uk/returns.An extended warranty may be purchased online (www.sangamo.co.uk/warranty)CUSTOMER CARE POLICYAs part of Sangamo’s continuous improvement program, the Company operates a Customer Care Policy.This means that we welcome your comments and complaints, as it can help us to improve our services to you,our customer.Due to our policy of continuous product improvement and development, the specifications in this guide may be subject tochange without prior notice.Technical Helpline: 01475 745131 |
Related manuals for Sanyo choice pr 1
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved