Sanyo SIRIUS STILETTO 10 User Manual

Also see for CRSR-10: User guide User guide User guide User guide

Contents

Sanyo CRSR-10 User Guide Sanyo CRSR-10 User GuideSearching Channels (Channel List Mode)It is possible to search for a different channelwhile listening to your current channel. Be surethat the display shows the Default Screen priorto executing the following steps:1. Press and hold the DISP button for 2-secondsto activate the Channel List Screen (top right).The Channel List Screen will appear, showingall available channels regardless of category:• Pressing the DISP button while in theChannel List Screen will change the displaybetween Channel Name, Artist Name(middle right), and Song Title (bottom right).You can use this feature to search for aspecific Artist or Song that may be playing atthe time.2. Press the CHANNEL Button up or down to findthe channel you want.Press and Hold theDISP button to enterthe Channel ListModePress DISP again toshow the Artist NamePress DISP again toshow the Song TitlePress DISP again to goback to Channel ListSearch Modes (Category, Channel, Artist,Song)The CRSR-10 has four ways to search for and selectmusic: by category, by channel, by artist, and by songtitle.Searching CategoriesIf you want to listen to a different entertainmentcategory, push the CAT. button up or down to activatethe Category Select Screen (top right):1. Use the CAT. button to scroll through music andentertainment categories.2. When the category (ex. Rock) you want ishighlighted, use the CHANNEL Button to searchavailable channels within the category.• Pressing the DISP button while in the Categorysearch mode will change the display betweenChannel Name, Artist Name, and Song Titleenabling you to preview what is playing on otherchannels before selecting.3. When the channel you want is highlighted, press theSELECT Button. The channel will change and thedisplay will revert to the Default Screen for the newchannel. To exit this mode without changing to a newchannel, press and hold the DISP button for 2-seconds.Direct TuningChannels can also be directly accessed bypressing and releasing the SELECT Button whilein the Default Screen and using the 0-9 numberkeys to numerically enter the desired channel(below). Once the desired channel number hasbeen entered, press the SELECT button and thechannel will change and the display will revert tothe Default Screen for the new channel.Note: The CRSR-10 will change immediately ifthree numbers are entered (ex. “0”, ”0”, “7”), but ifjust one or two digits are entered, the unit willchange to that channel 4-seconds after the lastnumber was entered or immediately if you pressthe SELECT Button.3. Press and release the SELECT Button to select thechannel. To exit this mode without changing to anew channel, press and hold the DISP button for 2-seconds.1514Enter Channel# _ _ _001 Channel NameCategory 12:00P A