Sanyo PDG-DET100L Owner's Manual

Also see for PDG-DET100L - SXGA+ DLP Projector: Brochure & specs Owner's manual Specifications Service manual

Contents

54This function allows you to customize the screen logo with Logoselect, Capture, and Logo PIN code lock functions.Logo✔Note:• Before capturing an image, select “Standard” in the ImageSelect Menu to capture a proper image. (pp.39, 43)• A signal from a computer can be captured up to 1400 x1050 dots.•Certain signals may not be captured properly.• When capturing the image that has been adjusted by theKeystone function, the adjusted data is automatically resetand the projector captures an image without keystonecorrection.• When starting to capture a new image, the previouslystored image is cleared even if you cancel the capturing.• Once you exit the Logo Menu after setting the Logo lockto "On," you are required to enter the PIN code everyattempting to change the Logo setting.• “User” cannot be selected when the image is notcaptured.This function decides on the starting-up display fromamong the following options.Off . . . . Show the countdown display only.Default . Show the factory-set logo.User . . . Show the image you captured.CaptureLogo selectLogo✔Note:• When “On” is selected in the Logo PIN code lock function,Logo select and Capture functions cannot be selected.This function enables you to capture an image beingprojected to use it for a starting-up display or interval ofpresentations.Select Capture and press the SELECT button.A confirmation box appears and select [Yes] to capture theprojected image.After capturing the projected image, go to the Logo selectfunction and set it to “User”. Then the captured image willbe displayed the next time you turn on the projector.To cancel the Capture function, select [No].Set the red frame pointerto the item and press theSELECT button.CaptureSet the pointer (redarrow) to the item andpress the SELECT button.Select [Yes]to capturethe projectedimage.Select [Yes] to stopcapturing.SettingHDMI setupSelect Normal or Enhanced according to the output signalof video equipment. Press the Point 7 8 buttons to switchbetween each option.Normal . . . . When the output of video equipment is set to“STANDARD.”Enhanced . . When the output of video equipment is set to“ENHANCED.”The names for the output setting of video equipment varyfrom equipment to equipment. For details, refer to the owner’smanual of video equipment.When the black parts of the image are destroyed or stand out,please switch to "Normal" or "Enhanced", and then switch theoutput type of the HDMI video output equipment.HDMI setupPress the Point 7 8 buttonsto select Normal or Enhancedaccording to the output signal ofvideo equipment.