Sanyo IDC-1000ZE iDshot Instruction Manual

Also see for IDC-1000ZE iDshot: Service manual

Contents

The BATTERY CHARGE and AC ADAPTER lampsThe BATTERY CHARGE and AC ADAPTER lamps allow you to check the condition of thebattery pack and AC adapter/charger. If either of the lamps begins flashing, it indicates aproblem. Refer to the table below to check and remedy the problem.BATTERYCHARGE lampOff Power is not being suppliedœ Plug the power cord into a power outlet when usingthe AC adapter/charger.Charging is completeœ Unplug the power cord from the power outlet.On ChargingFlashing There is a problem with the battery packœ Immediately remove the battery pack.œ Do not use a malfunctioning battery pack (thebattery pack has likely ended its usable life).AC ADAPTERlampOff The AC adapter/charger is not connected properlyœ When running the digital disk camera with the ACpower supply, plug one end of the power cord intopower outlet and the other into the power supplysocket on the AC adapter/charger, and plug the DCcord into the DC IN terminal on the digital diskcamera.The digital disk camera is not turned onœ Press the power button to turn on the digital diskcamera.On AC power is being supplied to the digital disk cameraFlashing There is a problem with the AC adapter/chargerœ Immediately unplug the power cord from the poweroutlet.œ Do not charge the battery pack.œ Contact the place of purchase.HELPIf the BATTERY CHARGE lamp does not turn offœ If more than 150 minutes have elapsed since charging was begun and the BATTERYCHARGE lamp does not turn off, there is a malfunction. If this occurs, immediately stopcharging and contact the place of purchase.English 26