Sanyo HT28745 Owner's Manual

Also see for HT27745: Owner's manual Service manual

Contents

Sanyo HT28745 Owner's Manual Manual pdf 11 page image

11Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032USING THE REMOTE CONTROLREMOTE CONTROL KEYSPower Key—Press to turn DTV on or off.Input Key—Press to change the input signal sourceas follows: Analog RF Digital RF Video1 Video2Compo2 Compo3 Analog RF.Number Key—Two keys must be pressed to select adirect channel.Example: Press 0 then 6 to selectchannel 6. For Analog Cable channels above 100,press and hold the 1 key until C1– – appears.Info Key—Press to display the Digital and Analog FullBanner information (press again to remove thedisplay):Digital Full Banner display—Contains a two-partChannel Number (Major and Minor). If available thefollowing is also included–Station ID, Program Title,Date/Time (if set), Antenna Signal Strength, Video Res-olution, V-Chip Program Rating, and Audio Reception.Point towardsDTVPRECAUTIONSTo ensure safe operation, please observe the following precautions:Replace both batteries at the same time. Do not use a new battery witha used battery. Risk of explosion, if battery is replaced by an incorrecttype.Do not expose the Remote Control Unit to moisture, or heat.Virtual ChannelMajor Minor Station ID Time/DateProgramTitleAudioReceptionV-ChipProgramRatingVideoResolutionSignalStrengthAnalog Full Banner display—Contains ChannelNumber (analog antenna/cable), Date / Time (if set),Station ID (if available), Program Title (if available),V-Chip Program Rating, and Audio Reception.Station ID Current Time/DateProgram Title AudioReceptionV-Chip ProgramRatingChannel No.Recall Key—Select the first channel you want towatch; then select another channel using theNUMBER keys. Press RECALL to easily switchbetween the channels.NOTE: The RECALL key cannot toggle between aDigital channel and an Analog channel. See TUNER(#7) key description.Menu key—Press this key to display the on-screenmenu.Tuner Key—Use this key to toggle from one tuningsystem to another, digital channels, and analogchannels.NOTE: The TUNER key is inactive when an externalinput is selected (Video 1, Video 2, Compo 2, orCompo 3).Cursor (up) (down) keys—Press these keys tomove the cursor up and down within the menu.Cursor(left) (right) keys—Press these keys tomove the cursor left and right within the menu.(Continued on page 12.)