Sanyo DP15657 Owner's Manual

Also see for DP15657: Service manual

Contents

Sanyo DP15657 Owner's Manual Manual pdf 1 page image

CONNECTING A STEREOAMPLIFIER TO THE DTVCONNECTING A MULTICHAN-NEL RECEIVER TO THE DTVASLCD Owner’s ManualModel Nos.DP15657DP19657ENGLISHPart No.: 1JC6P1P0291 – –FIRST-THINGS-FIRST (REQUIRED INITIAL SETUP)1 Install batteries in remote control (2AA, not included)3 Plug in AC power cord (120V AC, 60 Hz.)4 Press the POWER key.(Follow on-screen instructions)5 Perform “All Channel Search.” The All ChannelSearch will search for off-air digital and analogchannels, and analog cable channels. The DTV willreceive cable or off-air channels, but not at thesame time. If after two searches the DTV still failsto detect any channels, the DTV will tune toVideo1.Note: IfEXIT is pressed,the DTV will skip ChannelSearch and tune to Video1without storing any chan-nels in the Channel Mapdatabase.PRECAUTIONSTo ensure safe operation, please observe the followingprecautions:Replace both batteries at the same time. Do not use a newbattery with a used battery.Risk of explosion, if battery is replaced by an incorrect type.Do not expose the Remote Control Unit to moisture or heat.1 Connect a Component cable to the VIDEO2 / 3Green, Blue, and Red video jacks.2Connect an Audio Cable to the VIDEO2 / 3White and Red audio jacks.3Press INPUT to select Video2 or Video3 toview the program.Note: VIDEO2 and VIDEO3 jacks have identicalfunctions. Compatible video devices can beconnected to either or both jacks.VIDEO 2 / 3 (COMPONENT VIDEO INJACKS)DTVDVD Player or similar digitaldevice, such as a Satellite Receiver2Y- Pb- PrComponentJacksOPERATING TIP:You DO NOT need to tune the TVto Channel 3 or 4 to view DVDprogram.Audio L/R JackPlease call us at1.800.877.5032 if you needassistance with your new HDTV.We can Help! Visit us at www.sanyoctv.comfor more information about these models.RF ANTENNACABLEORCABLE BOXor SATELLITE BOXORSpecificationsPower Requirement: Source: AC 120V, 60HzPower Consumption: DP15657: 40 wattsDP19657: 50 watts2 Connect Signal to the TV’s Integrated Analog / Digital75 ohm Antenna Input terminalCONNECTING A DVD ORGAME TO THE DTVCONNECTING A VCR OR DVD TO THE DTVVIDEO1 (ANALOG) JACKSVCR or DVDDTV AV Input Jacks1 Connect a Composite cable to the VIDEO1Yellow, White, and Red AV jacks.22OPTIONALConnect DVD to the TV S-Video In Jack, if avail-able on your external equipment.Note: S-Video jack connection overrides Video jackconnection (VIDEO1).3Press INPUT to select Video1 to view the VCR orDVD program. 1S-VideoJack(Optional)221 Connect a Multichannel Receiver to the TV DigitalAudio Output as shown.Note: Dolby ® Digital 5.1 audio is available at the DigitalAudio Output only when received as part of aDigital Antenna signal.DIGITAL AUDIO OUT JACKBack View of TVCoaxial CableMultichannel Receiver1If you experienceproblems, please call1-800-877-5032,We Can Help!Remote Control3IMPORTANT FACTS:Don’t be fooled by the phrase“Available in High-Definition.”Composite jacks offer only 480i(SDTV) resolution.To view available High-Definition(HD) programs, you must connectyour HD equipment to theComponent jacks.Enter Key—Press to select an option from themenu system, when required.Exit Key—Press to exit from the menu system. PIX Shape Key—Use to change the video displayformat. Available options depend on signalreceived and the broadcast’s aspect ratio. Note:Cannot display picture on a full screen. CheckAspect Ratio of broadcast. Then press PIX Shapekey to change setting. Reset Key—Press this key twice to restore factorysettings. The TV will automatically start ChannelSearch and clear all customized settings. Note:Channel scan memory database list of digitaland analog channels will be replaced. If desired,personal settings can be made again using themenu options. Audio Key—Press to select the desired audiomode (if available). Caption Key—Captioning is text informationtransmitted along with the picture and sound soit can be displayed on the TV screen.Press CAPTION to select mode options: DigitalCC1 ~ CC6, or Analog CC1 ~ CC4, OFF, orQuikCap. (QuikCap switches captions on and offwith the Mute function.) Digital Captions can bechanged using the menu settings. Mute Key—Press once to mute the sound.Recall Key—Press to switch between the lasttwo channels selected.Sleep Key—Press this key then the “0” key to setthe Sleep Off Timer. Time can be set in 30-minuteincrements up to 3 hours. Note:The Sleep Timercancels when the TV is turned off or if a power failureoccurs.1– – Key—For Analog Cable channels above 100,press this key, then press the other two numbers.Info Key—Press to display the Digital and AnalogFull Banner information. The banner contains thefollowing: program title, station ID, program rat-ing, signal strength, channel number, tuner ID,and audio information.1112REMOTE CONTROL OPERATION1314Pointtowards TV11121314 Input Key—Press to select the program sourceto watch: TV, Video 1, Video 2, or Video 3. Volume Keys—Press VOL – + to adjust. Number Keys—Press two keys to select a chan-nel. Example: Press 0 then 6 to select channel6. (See #13.)Channel Scanning (CH ) Keys—Press toscan through the channels in memory.Menu Navigational Keys:Menu—Press to display on-screen menu.Cursor (up) (down) keys—Press thesekeys to move the cursor up and down withinthe menu.Cursor < (left) > (right) keys—Press these keysto move the cursor left and right within themenu.StereoAmplifierBack View of TV1 Connect a Stereo Amplifier to the TVAudio Out jacks as shown.Note:Do not connect external speakersdirectly to the DTV.1AUDIO OUT (ANALOG) JACKSCompositeAVJack1Analog/ DigitalAntenna InDP15657Trademarks Information:Manufactured under license from Dolby Laboratories.“Dolby” is a trademark of Dolby Laboratories.Remote Control3Initial on-screenALL Channel SearchALL Channel Search [Analog & Digital]The Tuner in this DTV can receive:1. Digital and /or Analog Off-AirSignals from an RF antenna.OR2. Analog or ClearQAM cable chan-nels.Note: You must search for ClearQAMchannels using the “DigitalCable Search” menu option.OR3. The output from a VCR or cablebox.Digital signals from a Set-Top Box(STB) should be received throughthe Component In jacks.This DTV can receive ANY unscram-bled RF signal being broadcast.Game consoleY- Pb- PrComponentJacks12Audio L/RJack

/ 2

Related manuals for Sanyo DP15657