Sanyo DC X900 Instruction Manual

Also see for TP-X1000: Instruction manual

LISTENING TO THE RADIOMEMORY OPERATIONThis unit enables 12 stations FM1, FM2 and AM bands to be preset in thememory.Automatic presetting1,2.3.Select the band (FM1, ~M2 or AM) using the BAND SELECT switch.CLOCK FM 15:00PM 89.15 t&!zPress and hold down both UP and DOWN PRESET/APT switches forat least 3 seconds, until “MEMORY” blinks on thetuner/timer display.The unit starts automatic presetting from the low end of the band.When 24 FM or 12AM stations have been preset or the high end ofband is reached, automatic presetting stops. “MEMORY” disappearsand the preset number 1 station will be heard.Select another band and repeat step 2.Manual presetting1.2.3.4.Select the band.CLOCK AM5:00PM 531 kHzPress the UP or DOWN switch to tune in a station.Press the switch and release it when the frequency starts to change.The unit automatically stops at the next receivable station. Press theswitch again to continue.When receiving a station with weak signals, press the switchrepeatedly until the desired frequency is displayed. Each time theswitch is pressed, the frequency changes in 9 kHz steps for AMand 0.05 MHz steps for FM.Press the MEMORY switch.CLOCK AM5:00PMSelect the required preset number by pressing the UP or DOWNPRESET/APT switch, or one of the [1] - [12] switches on the remotecontrol.CLOCK AM MM~Y5: 00PM P 3 kHzThe frequency is replaced by the preset number.Note:When the band is selected by the controls on the main unit, be sure the[1] - [12] switches on the remote control are functioning as presetfunction switches (instead of CD 10KEY).5. Press the MEMORY switch to preset the station.“MEMORY” disappears and the original display returns.- If the next step is not taken within 30 seconds in the steps 3-5,“MEMORY” disappears and the memory operation is cancelled.Press the MEMORY switch to continue.6. Repeat steps 1-5, to add more preset stations.Clearing the memory1. Select the band.2. Select the preset number to be cleared by pressing the UP or DOWNPRESISf/APT switch or one of the [1] - [12] switches. The presetnumber appears.3. Press the CLEAR switch while the preset number is displayed (within2 seconds). The preset station will be cleared from the memory, butthe station will still be heard.Note:If a new station in the same band is programmed to a preset numberalready containing a programmed station, the previously pro-grammed station will be cleared.- If the memory contents are lost due to a power failure or othercondition, programme the stations again.LISTENING TO THE RADIO1, Select the band or select “TUNER”.2. Select the desired preset number by pressing the UP or DOWP.–PRES~/APT switch, or one of the [1] - [12] switches on the remotecontrol.The frequency is replaced by the preset number on the display. After2 seconds, the preset number is replaced by the received stationfrequency.If a preset number which has not been programmed is selected,“P - -“ appears for about 2 seconds and the previous station isselected.“STEREO” appears when an FM stereo broadcast is received.FM MODE switchIf the signals from an FM stereo station are weak and reception is poor,press the FM MODE switch tochangetomonaural reception, (“STEREO”is replaced by “MONO” in the display.)If a station is programmed while in the monaural mode, that station willbe received in MONO when the preset number for that station isselected.LISTENING TO RECORDS OR VIDEO SOURCES—Press the PHONO or VIDEO function switch, and listen to the sound.-9-