Sanyo 09KHS71 Instruction Manual

Also see for 09KHS71: Submittal data Specifications Installation instructions

21Adjusting the Airflow Direction1. Horizontal The horizontal airflow can be adjusted by moving the vertical vanes with yourhands to the left or right.When the humidity is high, the vertical vanes should be in the frontposition during the cooling or dehumidifying operation. If the verticalvanes are positioned all of the way to the right or left, condensation maybegin to form around the air vent and drip down.2. Vertical The vertical airflow can be adjusted by moving the flap with the remote controlunit. Do not move the flap with your hands. Confirm that the remote control unithas been turned on. Use the FLAP button to set either the sweep function or oneof the six airflow direction settings.• The flap automatically closes when the unit is off.• During the heating operation, the fan speed will be very low and the flap willbe in the horizontal position (position ) until the air being blown out of theunit begins to warm. Once the air warms up, the flap position and fan speedchange to the settings specified with the remote control.• Use the FLAP button on the remote control to adjust the position of theflap. If you move the flap by hand, the flap position according to theremote control and the actual flap position may no longer match. If thisshould happen, shut off the unit, wait for the flap to close, and then turnon the unit again; the flap position will now be normal again.• Do not have the flap pointed down during cooling operation.Condensation may begin to form around the air vent and drip down.CAUTIONA. Sweep functionThe flap starts moving up and down todeliver air over the sweep range.C. Auto flap functionThe flap is set to the recommendedposition.B. Setting the airflow manuallyReferring to the above illustration, use theFLAP button to set the airflow directionwithin the range used during the heating,cooling, or dehumidifying operation.COOLDRYFANHEATSWEEPSWEEPNOTECAUTIONOI-802-21EG