Sanwa M11X Operating Manual

Sanwa M11X Operating Manual Manual pdf 34 page image

Page 34track timersFunction Page 2 (TIMER)The Timer function features three different types of timers. Timers are provided for measuring Lap, Interval, and Countdown andCount-Up timers. These three timers can also be used simultaneously. In addition, a high degree of freedom and convenienceis provided by the ability to assign each of the timers to a switch to perform simultaneous or independent operation. Separatetones can be assigned to each of the timers, making it easy to distinguish between them during simultaneous operation. Theaudible signal provided by the Tone is complemented by a Vibrator*, which can be set to operate either in concert with the tone,or simultaneously. The operational status of the timers is also displayed in the Information Window.[LAP] LAP TIMErThe Lap Timer function allows you to measure and record times for up to 99 laps. Featured are a Pre-Alarm (PRE-ALM), theability to set a (GOAL) time, a real-time display of the best lap time (BEST), average lap time (AVE), and total (TOTAL) laps.Turning On the Lap Timer (Count-up Timer)1) Press the Function key to highlight the TIMER menu. [LAP] will beactive in the Programming Window and the cursor will default to OFF.2) Press INC/+ or DEC/- keys to turn the Lap Timer ON.TIMER LAP GOAL setting range is 10 seconds to 60 minutes in 10 secondincrements. The default setting is 60 minutes.The Pre-Alarm sounds the programmed number of seconds prior tothe GOAL Time.TIMER LAP PRE-ALM setting range is OFF and 1 second to 20 seconds.The default setting is 5 seconds.Pointer RevolvesWhile Timer isRunningTimer DisplayFUNC1FUNC2FUNC3The timer status appears in the Information Window.The timers appear in the timer display area in the orderFUNC1>FUNC2>FUNC3, as set using the Key Assignfunction. See page 50 for more information. In the exampleat right, LAP appears as assigned to FUNC1.GOAL Time Setting1) Press the ENTER key to move the cursor to GOAL in the ProgrammingWindow, then press INC/+ or DEC/- keys to set the desired GOAL value.Pre-Alarm Setting1) Press the ENTER key to move the cursor to PRE-ALM in the ProgrammingWindow, then press INC/+ or DEC/- keys to set the desired PRE-ALMvalue.00' (Minutes) 00" (Seconds) 00 (Milliseconds).*See page 46 for more information.