SANGFOR IAM v2.1 User Manual13WAN1 Interface: Network interface, to be defined as WAN1, LAN, or DMZ interfaceWAN2 Interface: Network interface, to be defined as WAN2, LAN, or DMZ interfacePOWER: Power indicator of IAM gateway deviceALARM: Alarm indicator of IAM gateway device (it keeps on for one minutewhile the device is starting up) Normally, the ALARM indicator keeps on lighting (in red) when the device is starting andgoes out in about one or two minutes, indicating successful startup of the device. Afterstartup, the ALARM indicator may flash, which means the device is writing logs; however,if the ALARM indicator stays lighted for a long time and does not go out, please shut downthe device, and about 5 minutes later restart the device once again. If this situation remainsafter restart, please contact our Customer Service to confirm whether the device is damaged. The CONSOLE interface is only for debugging by technicians. The end users connect to thedevice via the network interfaces.1.4. Configuration and ManagementBefore configuring the device, please prepare a computer and make sure the web browser (forexample, Internet Explorer browser) of the computer can be used normally. Then connect thecomputer to the IAM gateway device (in a same local area network) and configure the IAMgateway on the computer over the established network.1.5. Wiring Method of StandaloneConnect the power cable to the Power interface on the rear panel of the IAM gateway device andswitch on the power supply. The POWER indicator (in green) and ALARM indicator (in red) onthe front panel will be lighted. The ALARM indicator will go out one or two minutes later,indicating the device runs normally.Follow the instructions below to wire the interfaces:Use standard RJ-45 Ethernet cable to connect the LAN interface to the local area network and thenconfigure the IAM gateway device.Use standard RJ-45 Ethernet cable to connect the WAN1 interface with the networking device,
