Samsung SSA-R2010 Operation Manual

Also see for SSA-R2010: User manual

SSA-R2041 Operation guide1. Provide DC12V power to SSA-R2041. “WELCOME TO ACCESS CONTROLSYSTEM ” voice message will activate. If master card is not registered“MASTER ID REGISTRATION MODE” will activate with red, green, yellow ledblinking. If master card is registered, “Reader MODE” voice will activatewith red led on.2. The mode will change from the “Reader Mode” to the “Master Mode”.Green & yellow led will blink. Following voice message will be activated“REGISTRATION AND DELETION MODE, SCAN YOUR CARD” Once mastercard that you wish to register has been scanned to SSA-R2041, mastercard will be registered. Then automatically mode will shift to reader modewith “READER MODE” voice message.3. User may register and delete the card in Master mode. Present the card toSSA-R2041 and card will be registered with the buzzer sound. If the card isalready registered, the buzzer will sound 4 times with voice message.4. User may control Buzzer of SSA-R2041. To do so, connect power first.Then connect gray with red stripe to NO, and COM to GND. Once wiringconnection is done you may change the Buzzer by input & output setting ofaccess controller. When activated, buzzer will be on. Such function may beuseful to add buzzer sound for access granted or denied.5. User may control LED of SSA-R2041. To do so, connect power first. Thenconnect blue with white stripe to NO, and COM to GND. Once wiringconnection is done you may change the LED status by input & outputsetting of access controller. When activated, green led will be on.6. Connect the power to SSA-R2041. Connect gray with red stripe to NO wire.Then connect GND wire to COM wire. Once wiring connection is done youmay change the system mode operation by input & output setting of accesscontroller. When system mode is activated, unit will operate as RF Only.

/ 2

Related manuals for Samsung SSA-R2010