Samsung SNH-1010N Troubleshooting Manual

Also see for SmartCam SNH-1010N: User manual User manual Quick start guide Quick start guide Quick start guide

English · 1You can’t make a connection using “WPS” between your router and thecamera. What’s “WPS”?WPS enables to make connection between the camera and theWireless Access Point with a simple click of the button.Reason1. Your router doesn’t support “WPS” function.2. Your router can’t work well with the camera.SolutionHow to check if your router supports “WPS” or not.• Refer to your router manual or contact to the manufacturer of your router.In case your router doesn’t support it, refer to Quick Guide describing “Connectingvia Wi-Fi without WPS feature” or “Wired Connection”.Operation Flow1. The camera power “On”2. Front LED is red.3. After about 1minute, front led is blinking white.4. Press the WPS button on the camera.5. Press the WPS button on the Wireless Access Point within 2min.6. The Wi-Fi status LED will become steady white once the camera is connected tothe Wireless Access Point. (may take up to 30sec).If the Wi-Fi status LED (white) is not lit, repeat steps 2 through the end and checkit again.7. The Wi-Fi status LED will became steady white once the camera is connected toserver.J ` We tested WPS function with many routers. But there are some cases that the cameracan’t make connection with the router. So in that case we recommend you choose theother methods describing on your Quick Guide. (ex. Connecting via W-iFi without WPSfeature or Wired Connection.)Problem Case 01Network Troubleshooting GuideSNH-1010NWPS Button WPS ButtonInternet ServiceWi-FiIndicator LED

/ 3

Related manuals for Samsung SmartCam SNH-1010N