Menu
Samsung SKK-8 Series Installation Instructions Manual
  |
CAUTION : Two people are required to lift the dryer on tothe washer.WARNING : These washer and dryer are not suitable formobile home or RV installation.DryerSTEP 1 Have two persons place the dryer on a non-slipperyfloor. Then, have one person tilt the dryer to the side.Do not lay the dryer down. The dryer may be scratched.STEP 2-1 SKK-7*, SKK-8*: Check if the legs are tightened up,and then insert the stacking support guides in therectangular holes of the dryer’s base until you hear aclicking sound. You don’t need to remove the legs.STEP 2-2 SKK-BB: Disassemble legs, and Snap the stackingsupport guides into the rectangular holes in the dryerbase and secure each with two(2) screws Phillips-panhead (6006-001174)STEP 3 Repeat the same step above on the other side.STEP 4 Bottom view of the dryer after assembling the StackingSupport Guides to the dryer base.* Use a stacking-kit compatible with the purchased model.Washer (Stacking kit: SKK-7*, SKK-8*, for 27” models)CAUTION : You need to use the proper rear bracketdepending on your washer model. (There are 2 differentrear brackets : DC61-04160A, DC61-04955A)5-1) DC61-04160A :WF5*K**, WF4*H**, WF4*K**, WF4*M**, WF4*N**,WF18H**, WF20H**, WF20M**, WF22H**, WF22K**,WF15K**, WF16J65**Left RightDO NOT TIGHTEN SCREWS COMPLETELYSTEP 5-1 LOOSELY assemble the Rear Brackets(DC61-04160A) to the washer as shown below. Usetwo (2) Screws-Hex Head (6002-001431) with washers(DC60-00044A) in each washing machine Top Cover tail,per bracket.* Before installing the rear bracket, loosen two screws(Screw-Hex) on the Cover Top that is secured to the frame.5-2) DC61-04955A :WF5*R**, WF4*R**Left RightDO NOT TIGHTEN SCREWS COMPLETELYSTEP 5-2 LOOSELY assemble the Rear Brackets (DC61-04955A)to the washer as shown below. Use two (2) Screws-HexHead (6002-001431) with washers (DC60-00044A) ineach washing machine Top Cover tail, per bracket.* Before installing the rear bracket, loosen two screws(Screw-Hex) on the Cover Top that is secured to the frame.Washer (Stacking kit: SKK-BB, for 30” models)WF56H**STEP 5-3 Loosely assemble the Rear Bracket (DC61-03846A) tothe washer as shown above in either case A or Case B,Use (2) Screws-Hex Head (6009-001476) with washers(DC60-00044A) to the each hole of Cover Top and Frame.* Case A only : Before installing the rear bracket, loosen two screws(Screw-Hex) on the Cover Top that is secured to the frame.Case A Case BSmall Cap Big CapSTACKING KIT INSTALLATION INSTRUCTIONS (WASHER & DRYER ONLY)DC68-01052R-09StakingKit_DC68-01052R-09_EN.indd 1 2019-03-08 2:27:50 |
Related manuals for Samsung SKK-7 Series
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved