Samsung SH-S203B User Manual

Also see for SH-S203B: User guide User guide

4Connecting the Cables to theDVD WriterConnecting the CablesConnecting the power cable• The 4-pin power cable from the internal power unit of your computer mustbe connected to the power terminal the rear of the DVD Writer drive.12 Connecting the S-ATA cableS-ATA Power cableS-ATA Data cableS-ATA Data cableS-ATA Power cable3Emergency eject hole LEDDisc compartment Eject ButtonIf the compartment does not openwhen you press the Eject button,power off the computer, insert a pinor unfolded paper clip in the holeand push firmlhy)FrontRearS-ATA Power cable S-ATA Data cableAccessoriesUser Guide, Screw 4eaThe type of accessories varies depending on a product model.and some accessories described herein are subject to change without notice.Introduction• Design and specifications are subject to change without prior notice.DVD WriterSH-S203B(TS-H653B)/SH-S203D(TS-H653D)Safety PrecautionsThe following are basic precautions to ensure user safetyand reduce the risk of property damage.1 2When you install the driveWhile operatingOtherPlace the drive on a levelsurface.• Do not place the drive indirect sunlight.• Avoid low- or high-temperatureenvironments.• Avoid high-humidity environments.Handle with caution to preventdamage from an external shock.Do not drop the drive, and pro-tect it fromsevere shocks.• It can damage the drive or causeit to malfunction.Do not move the drive while in operation anddo not attempt to open the disc tray byforce.Make sure to close all working programs beforeattempting to open the tray and always use theopen/close button.Do not use cracked, distorted ordamaged discs.Do not insert a pin into the emergency open-ing while in operation.In particular, a disc with a crack on theinner tracks may break while in use.• Never allow food particles orforeign substances to enter thedrive casing.• To protect against the risk offire, do ot spill such liquids asalcohol and benzene on thedrive.Do not disassemble, attempt to repair ormodify the device without an expressapproval as directed in the manual.• To reduce the risk of damage,electric shock, and fire.Important to read and understandat all times Do not disassemble1. Check to see that the disc does not have a crack before use.If the disc has a crack (especially around the center hole),it is recommended that you make a copy immediately anduse the copy instead.When a cracked disc is used continuously,the size of thecrack is likely to grow and it will eventually result in irreparabledamage to the disc.2. Do not use low quality discs (i.e., illegal products, scratched ordamaged discs).• Any change or modification not expressly approved by designated qualified personnel couldvoid your authority to operate this device.Warning/CautionWarning: To warn the user that failure to comply with the instructions may result inserious injury or death.Caution: To caution the user that failure to comply with the instructions may result indamage to property.• Failure to do so may cause thedevice to fall onto a hard surface,resulting in damage or malfunction.User Guide - ENGLISHFCC ComplianceThis equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC rules.These limits are designed to provide reasonable protection against harmful interference in aresidential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio com-munications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception,which can be deter-mined by turning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the following measures:• Re-orient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.This mark shown on the product or its literature,indicates that it should not be disposed withother household wastes at the end of its working life.To prevent possible harm to theenvironment or human health from a uncontrolled waste disposal,please separate this fromothertypes of wastes and recycle it responsibly to promote the sustainable reuse of materialresources.Household users should contact either the retailer where they purchased this product,or theirlocal government office,for details of where and how they can take this item for environmentallysafe recycling.Business users should contact their supplier and check the terms and conditions of the purchasecontract.This product should not be mixed with other commercial wastes for disposal.CAUTIONChange or modifications not expressly approved by the manufacturer responsible forcompliance could void the user ’s authority to operate the equipment.LASER STANDARDIEC 60825-1 :1993 +A1 :1997 +A2 :2001WEEECorrect Disposal of This Product (Waste Electrical &Electronic Equipment)(Applicable in the European Union and other European countries with separate collection systems)- http://www.samsung-ODD.com- http://www.samsung.comBG68-01412A REV.02• Samsung Eco-markThe Samsung’s own Eco mark helps consumers to easily understand thatSamsung develops eco-friendly products. This mark represents Samsung’scontinuous effort to develop eco-friendly products.• RoHS(Restriction of the use of certain hazardous substances in electrical and electronic equipment)The RoHS, the environmental regulation announced by European Union, restricts theuse of lead, mercury, cadmium, hexavalent chromium, PBB, and PBDE in products puton the market in The European Union after July 1, 2006.9Technical SpecificationsSH-S203B(TS-H653B)/SH-S203D(TS-H653DDVD WriterCategoryDISC Usable DiscsDisc DiameterDVD : DVD-R, DVD-RW, DVD+R, DVD+RW, DVD-ROM,DVD-Video, DVD+R(DUAL) , DVD-R(DUAL), DVD-RAMC D : CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G) CD-MIDI, CD-TEXT,CD-ROM XA, Mixed Mode CD ‚ CD-I, CD-I Bridge (Photo-CD, VideoCD), Multisession CD(Photo-CD, CD-EXTRA, Portfori4.72 Inch or 3.15 Inch (120mm or 80mm)S-ATACD-ROMDVD-ROMDVD+RMedia type Write ReadDVD+RWDVD+R DUALDVD-R DUALDVD-RDVD-RWDVD-ROM(Single)DVD-ROM(Dual)CD-ROMCD-RUS-RWHS-RWCD-RWS-ATA 1.5Gbps110ms (Random)130ms (Random)5.34 X 1.65 X 6.69 Inch (148.2 X 42 X 170mm)5 ~ 10% (RH)41°F ~ 122°F (5°C ~ 45°C)2MBHorizontal / vertical750 gData TransferSpeed(MAX)Access time(Random)Buffer MemoryDrive InstallationTemperatureHumidityOperatingEnvironmentWeightSize(Width x Height x Length)Interface PortInterfaceSupport Burst Transfer RateDVD-RAMCAV20X CAV16XZCLV 8X CAV 12XZCLV16X CAV 12XZCLV12X CAV 12XCAV20X CAV16XCLV 6X CAV 12X- CAV16X- CAV 12X- CAV48XPCAV48X CAV40XZCLV32X CAV40XCLV10X CAV40XCLV 4X CAV40XCAV12X CAV12X8Solving Technical ProblemsThe tray won't open. • See if the PC is on.• Make sure the power cable within the PC is connected properly.• If the tray still won't open with the power-on, turn the power-offand insert a pin(paper clip) into the emergency hole to open.The tray won't close. • Make sure the disc has been inserted properly.The PC is not working properly. • See if the jumper(s) is properly connected to the Master/SlaveSelection port.• See if the drive is properly connected to the PC.See if the floppy disc remains in the PC.The drive is not working properly. • See if the drive is connected properly to the PC.• See if the device drive program has been installed properly.The Window OS can't detect thedrive.• See if the device drive program has been installed properly.• Can be an OS problem. Try to reinstall the Windows OS program.The system won't read the disc.You can confirm the use of software at the site of our customer support.Address: www.samsungODD.com- See “ Customer support > Download center > User’s manual(PDF) > Software ”.- See “ Information > Movie manual > Recording software ”.• See if the system detects the drive.• Make sure you use the types of discs that are supportedby the drive.• See if the on/off light turns into green.• Make sure you inserted the disc with the label facing up.• Make sure you are using the right program for disc play-back.• See if the disc is clean.• See if any congealing has occurred.• Make sure the region code of the drive matches the discnumber.• The friction noise generated during SPIN-UP and STOP is caused by theAutomatic Ball Balancing System(ABS) and is not a malfunction.7Using the Drive/Storing and CleaningYour DiscsPush the power button and boot the computer.1After booting the computer, open the disc com-partment by pressing the Eject button.2Insert the disc (CD) with the label on the discfacing upwards and close the disc compartmentby pressing the Eject button. The indicator lightcomes on.3Play the disc (CD).4Using the DVD Writer• Do not place a disc in direct sunlight.• Store a disc vertically in a well-ventilated andstable location.• Do not write or attach a label on a disc.• Do not drop a disc or place heavy objects on it.• Do not touch the surfaceof a disc; hold it by theedges.• To clean a disc, polish lightlyfrom the inside of the disc to theoutside with a soft cotton cloth.Storing Your DiscsCleaning Your Discs• Run the CD player program supplied with the sound card or play theWindows Media Player.Playing CD-DA/Audio CDs• Follow the instructions provided with the disc.• A video card or MPEG software and a sound card need to be installed to view video CDs.Playing Video CDs• The disc may not function properly if there are fingerprints, foreign substances ordust on the disc surface.• If the drive is vertically installed, you cannot use an 8 cm Mini Discbecause the disc is movable.6Installing the DriveInstalling the DVD WriterIf necessary, attach a horizontal bracketto both sides of the drive.• You can purchase these accessories separatelyfrom your computer dealer.(Screws for use: M3 X 6 X 4)1Remove the plate from a free expansion slot and install theDVD Writer , as shown in the illustration.• If you have no free expansion slot, install the drive in place of thediskette drive.• Make sure to use the standardized screws supplied (M3X6).- To use screws other than M3X6 may result in malfunction.S-ATA supported PC(The compatible motherboard list can be found from the website)256Mbytes or above2How to install the DVD Writer on your PC. First, remove the cover; con-nect the cable to the DVD Writer and then to the PC.DVDWriterHorizontalBracketPlateSystem Requirements5When using one S-ATA cableMainBoardDriveHard DriveWhen you have one ODD and the other ODD products.Hard Drive MainBoardSlave DriveMaster DriveSH-S203B(TS-H653B)EN/RU 2007.8.13 2:12 PM Page 1All manuals and user guides at all-guides.comall-guides.com

/ 2

Related manuals for Samsung SH-S203B