Samsung SDS SHP-DH538 User Manual

SHP-DH52564&3."/6"-www.samsungsds-nss.com/enConvenient OpeningUser friendly access with cards and passwordWelcome FunctionWhen a user gets close to the door lock,the authorization standby mode willautomatically activate.Silent-Mode FunctionWhen going in or out, the sound of thekey entering and door opening will besuspended.Security Assurance FunctionWhen someone is inside the house,authorization for entry from the outsidewill be prohibited.Built-in Fire DetectionGenerates alarm in case of a fireSecurity FunctionPrevents intrusion from the outsideSmartphone Interworking functionGConveniently open the door through the Bluetoothfunction of a smart phoneWarning2 34 5 6Key Tag (2EA)User Manual, Product Warranty‘AA’ Batteries (LR6)Emergency KeyHandle Shaft SpringHandle Shaft, Installation ScrewsInstallation ManualBIOMETRICSCARDBIOMETRICSCARDBIOMETRICSCARDWhen purchased, the product is set to Multi-leveled Security Code Entry Modeinitially. Please refer to “Multi-leveled Security Code Entry Mode setting” for Com-mon Mode setting.※ Silent ModeBefore entering the password, press the [] button and enter the password, then boththe sound of the key entering and the door opening will be suspended. It is a usefulfunction if you do not want to disturb neighbors when you go in and out at night.Safety CautionsThis section contains important information to ensure the user’s safetyand prevent potential damage to property. Please, read this sectioncarefully and use the product accordingly.• The user shall not install or repair theproduct without authorization.• Do not install the product in the placewhere the gap between the door and theframe is 5mm or more.• Make sure that no unauthorized personhas the access to the password.• Do not operate the product with wethands, and keep liquids such as wateror drinks away from the product, or theproduct may malfunction or be damaged.• Do not use the excessive force or sharpobjects to push the lockbuttons, as thiscan damage the product.• Make sure that the door is completelyclosed when going outside. Themanufacturer does not assume theresponsibility for any harm caused byengagement of the lock on an improperlyclosed door.• Please do not hang on the product or pull it.• Long-term exposure to direct sunlightmay cause a crack on its touch pad.Avoid exposure to direct sunlight duringinstallation.• During battery replacement, use a new oneinstead of the existing battery.• Be sure to correctly match the poles (+/-)when installing the batteries. Install thebatteries with the correct poles (+/-).• Do not use water, benzene or alcohol whencleaning the product, as these fluids cancause product malfunction.• Replace the batteries within 1 week afterthe battery replacement alarm sounds.• Interference in wireless communication mayoccur when this product is used.• According to the wireless communicationenvironment, its battery may consumemuch.Product ComponentsThe product components used may vary depending on the installationenvironment.Outer Body PartsNumber PadUnlighted Touch Number Pad Number Pad LightedProximity SensorNumber PadAway SecuritySetupEmergency AlertLightDouble Lock LightExternal PowerContact PartReset SwitchEntry Complete/Silent ModeSwitch ButtonBatteryReplacementTime AlertInner Body PartsSound Control SwitchBuilt-in WirelessModule (Optional)Auto/ManualLocking SwitchManual Open andclose LeverBattery CoverRegistrationButtonInner BodyHandleCLOSE ButtonMortiseOpening the Door from Outside with a Password1. Multi-leveled Security Code Entry Mode2. Common ModeTouching [NumberPad] will light upthe number pad.Touching [NumberPad] will light upthe number pad.When two arbitrary but-tons are lighted, pressthe buttons in order.When the numbers on the numberpad are lighted, enter the passwordand press the [] button.Enter the password when thenumber pad is lighted, and press the[] button.Success:DING DONG DENG DONGFail:DING DONG DING DONGSuccess:DING DONG DENG DONGFail:DING DONG DING DONGNote● Password must be entered after the light is on, and if does not, touch[Number Pad] and re-enter.● To cancel, press [ ] button and re-enter.● If the password is wrong 5 times, “peep” warning alarm will sound 20 timesand the system will shut-down for about 3 minutes. When malfunctionhappens, “beep” will sound every 10 seconds, and stop mode will beturned off automatically after 3 minutes with multiple ‘beeps’.Opening the Door from Outside with a Card or Key TagThe door can be opened from outside using a card or key tag.Place the registered card or key tag on the card reader.Placing the Card or Key Tag on the Card ReaderSuccess:DING DONG DENG DONGFail:DING DONG DING DONGPlace the card or key tag onthe card reader.The door will be opened after1 second.Opening the Door from the InsideAutomaticLocking Setting The door is automatically locked 1 seconds afterthe door is closed.Closing the Door from the InsideNote● To check if the door is locked from the inside, press the security button briefly;the red LED will flash if the door is locked and the blue LED will blink if the dooris unlocked.● For 5 seconds after the door is closed, the Bluetooth authentication mode isnot turned on even though you approach the door lock.(Note that the Bluetooth mode is turned on when you touch the number pad.)Card and Key Tag RegistrationUp to 20 cards, including the key tag, can be registered.(Only ISO14443 A Type is available.)1. Pressing the [Register] Button(from the inside)DING DONGOpen the battery cover of the inner bodyand briefly press the [Register] button.2. Entering the Password(from the outside)DING DONG DENG,DING DINGEnter the password (‘1234’ after initial-ization) when the number pad is lighted,and press the [] button.- If the security mode is changed as ‘common mode’, second step will be skipped.When the number pad is lighted, enter‘4560852580’ and then press the [] button.Press and hold the [Register] button for5 seconds.DING DONG DING DING DING DINGDING DINGInitialization (Password, Bluetooth,Card, Key Tag)All registered data (password, Bluetooth, card, key tag) are deleted. After initial-ization, the password is set to ‘1234’, and the registered card, key tag data areerased. Please register a new password after initialization.1. Pressing the [Register] Button(from the inside)2. Entering the Numbers forInitialization (from the outside)Success: DING DONG DENGFail: DING DONG DINGDONGGC68-02211B ED:03Outer Body Inner BodyCard ReaderOuter BodyHandlePulling down the Door Lock HandleRotate the door lock handle of the inner bodydownward.DING DONG DENG4. Checking New Password Operation(from the outside)DING DONG DENGDONGTo make sure the password has beenproperly registered, check the newpassword and close the door.Warning● Manage your password with care so that unauthorized people will nothave access to it. Regularly changing your password can reduce therisk of it being leaked.3. Entering a New Password(from the outside)DING DING DENGEnter the new password (4 to 12 digits)and press the [] button.CARD CARD3. Placing the Card or Key Tag on theCard Reader (from the outside)4. Confirming Card or Key TagRegistration (from the outside)DING DONG DENGPlace the card or key tag to be registered onthe card reader of the outer body. You willknow the card or key tag has been registeredwhen “DING DONG DENG” sounds.Place the registered card or key tagto the card reader on the outer body.Warning● To register multiple cards or key tags, lightly place another card or key tagto the card reader within 20 seconds after registering the previous card orkey tag.ManualLocking Setting The door is locked when the [Close] buttonis pressed.StrikeboxMortise(SHS-AML220) StrikeMortise(SHS-AML320) StrikeOrDeadboltLatch boltOpen-doorsensorSHS-AML320 SHS-AML220You can delete all registered cards.Deleting Registered CardsEnter the current passwordwhen the number pad islighted, and press [] button.If the number pad is lights,enter ‘88’ and press []button.DING DONGDING DING1. Pressing the [Register]Button (from the inside)Open the battery cover of theinner body and briefly press the[Register] button for 3 seconds.2. Entering the CurrentPassword(from the outside)3. Entering the number(from the outside)DINGDONGDENGDINGDONGDENG2. Entering the Current Password(from the outside)DING DONG DENG,DING DINGEnter the current password (‘1234’ afterinitialization) when the number pad islighted, and press the [] button.Password ChangeThe password can be 4~12 digits number. Only one password can be registered.1. Pressing the [Register] Button(from the inside)DING DONGOpen the battery cover of the innerbody and briefly press the [Register]button.

/ 2

Related manuals for Samsung SDS SHP-DH525