Samsung SCX-812 Series User Manual

Also see for CLX-92 1 Series: Installation guide

Regulatory information_ 19Ringer Equivalence NumberThe Ringer Equivalence Number and FCC Registration Number for this machine may be found on the label located on the bottom or rear of themachine. In some instances you may need to provide these numbers to the telephone company.The Ringer Equivalence Number (REN) is a measure of the electrical load placed on the telephone line, and is useful for determining whetheryou have “overloaded” the line. Installing several types of equipment on the same telephone line may result in problems making and receivingtelephone calls, especially ringing when your line is called. The sum of all Ringer Equivalence Numbers of the equipment on your telephoneline should be less than five in order to assure proper service from the telephone company. In some cases, a sum of five may not be usable onyour line. If any of your telephone equipment is not operating properly, you should immediately remove it from your telephone line, as it maycause harm to the telephone network.The equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the right lower side of this equipment isa label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must beprovided to the telephone company.FCC Regulations state that changes or modifications to this equipment not expressly approved by the manufacturer could void the user’sauthority to operate this equipment. In the event that terminal equipment causes harm to the telephone network, the telephone companyshould notify the customer that service may be stopped. However, where prior notice is impractical, the company may temporarily ceaseservice, providing that they:a) promptly notify the customer.b) give the customer an opportunity to correct the equipment problem.c) inform the customer of the right to bring a complaint to the Federal Communication Commission pursuant to procedures set out inFCC Rules and Regulations Subpart E of Part 68.You should also know that:• Your machine is not designed to be connected to a digital PBX system.• If you intend to use a computer modem or fax modem on the same phone line as your machine, you may experience transmission andreception problems with all the equipment. It is recommended that no other equipment, except for a regular telephone, share the line withyour machine.• If your area experiences a high incidence of lightning or power surges, we recommend that you install surge protectors for both the powerand the telephone lines. Surge protectors can be purchased from your dealer or telephone and electronic specialty stores.• When programming emergency numbers and/or making test calls to emergency numbers, use a non-emergency number to advise theemergency service dispatcher of your intentions. The dispatcher will give you further instructions on how to actually test the emergencynumber.• This machine may not be used on coin service or party lines.• This machine provides magnetic coupling to hearing aids.You may safely connect this equipment to the telephone network by means of a standard modular jack, USOC RJ-11C.Replacing the Fitted Plug (for UK Only)ImportantThe mains lead for this machine is fitted with a standard (BS 1363) 13 amp plug and has a 13 amp fuse. When you change or examine thefuse, you must re-fit the correct 13 amp fuse. You then need to replace the fuse cover. If you have lost the fuse cover, do not use the plug untilyou have another fuse cover.Contact the people from you purchased the machine.The 13 amp plug is the most widely used type in the UK and should be suitable. However, some buildings (mainly old ones) do not have normal13 amp plug sockets. You need to buy a suitable plug adaptor. Do not remove the moulded plug.If you cut off the moulded plug, get rid of it straight away.You cannot rewire the plug and you may receive an electric shock if you plug it into a socket.