OfficeServ 100 Installation Manual/Ed.00© SAMSUNG Electronics Co., Ltd. 4-3MP(XRC855T in the MCP1 Board) Processor Status: MP Run LEDOFF indicates that Power is OFFMPON indicates that the MP is booting Flicker indicates normal operation.SP(68EC000 in the 008 Base Board) C#2) Processor Status: SP Run LEDOFF indicates that Power is OFFSPON indicates that the SP is booting Flicker indicates normal operation.4.3 Card VerificationBefore connecting all MDF cable, plug in a test cable to the first DLI port. Connect adigital Telephone set and verify that it is working. Use maintenance program MMC 727 toverify the system version, and that all cards are recognized by the CPU. Remove the testcable and plug in all Amphenol-type cables to the MDF. At this time, it is recommendedthat the system be defaulted using MMC 811.See the Programming manual for more details. Proceed with the rest of the installation.4.4 Default Trunk and Station NumberingUpon initial power up, the CPU reads each slot for the existence of a card and identifies thetype of card. It stores this as the default configuration.The system assigns trunk numbers beginning with 701 and continues. Station numbers areassigned in the same manner. The lowest station is assigned station number 201 andcontinued Keyset daughter boards are assigned numbers beginning with 301 and continued.Default data assigns the 24 button phone in the lowest port to the operator group and alltrunks ring that station until default is changed. It is recommended that the operator stationwill default to a 24 button key set as extension 201.Station and trunk numbers can be changed, rearranged and reassigned as needed usingMMC 724.
