Samsung NX58M5600S Series Installation Manual

Also see for NX58H5600S series: Installation manual Installation manual User manual User manual User manual

safety instructions _5SAFETY INSTRUCTIONSTo prevent accidental tipping of the range, attach an approved and packedanti-tip device to the floor. (See Install the Anti-Tip Device on page 31 in thismanual.) check for proper installation by carefully tipping the range forward.The anti-tip device should engage and prevent the range from tipping over.If the range is pulled out away from the wall for any reason, make sure the anti-tip device is reengaged after the range has been pushed back into place.Never completely get rid of the leveling legs or the range will not be secured tothe anti-tip device properly.Follow the installation instructions found on page 28 of this manual. Failure tofollow these instructions can result in death, serious personal injury, and / orproperty damage.DO NOT step / sit / lean on the door or drawer to prevent accidental tipping ofthe range.IMPORTANT SAFETYPRECAUTIONSWARNINGFollow basic precautions when installing and using this range to reduce the riskof fire, electrical shock, injury, or death to persons, including:Installation and ServiceThis range must be properly installed and located in accordance with theinstallation instructions before it is used.Professional installation is strongly recommended.Due to the size and weight of the range, it is highly recommended that two ormore people move or install this appliance.All ranges can tip over and cause severe injuries. Install the anti-tip devicepacked with this range following the instructions found on page 32 in thismanual.Never try to repair or replace this appliance on your own unless it is specificallyrecommended in this manual. This appliance should be serviced only by aqualified service technician.Know the location of the gas shut-off valve and how to shut it off if necessary.Properly remove or destroy the packaging materials after the appliance isunpacked.Electrical/MechanicalUnplug or disconnect power before servicing.