Samsung HW-Q600A Full Manual

Also see for HW-Q600A: Full manual Full manual Full manual

ENG - 16Disconnecting the Soundbar from the TVPress the (Source) button on the top panel or on the remote control and switch to any mode but “BT”.• Disconnecting takes time because the TV must receive a response from the Soundbar.(The time required may differ, depending on the TV model.)• To cancel the automatic Bluetooth connection between the Soundbar and TV, press the Left buttonon the remote control for 5 seconds with the Soundbar in “BT READY” status. (Toggle On → Off)What is the difference between BT READY and BT PAIRING?• BT READY : In this mode, you can search for previously connected TVs or connect a previouslyconnected mobile device to the Soundbar.• BT PAIRING : In this mode, you can connect a new device to the Soundbar. (Press the PAIR buttonon the remote control or press and hold the (Source) button on the top of the Soundbar formore than 5 seconds while the Soundbar is in “BT” mode.)NOTES• If asked for a PIN code when connecting a Bluetooth device, enter <0000>.• In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between theSoundbar and the Bluetooth device exceeds 10 meters.• The Soundbar automatically turns off after 20 minutes in the Ready state.• The Soundbar may not perform Bluetooth search or connection correctly under the followingcircumstances:– If there is a strong electrical field around the Soundbar.– If two or more Bluetooth devices are simultaneously paired with the Soundbar.– If the Bluetooth device is turned off, not in place, or malfunctions.• Electronic devices may cause radio interference. Devices that generate electromagnetic wavesmust be kept away from the Soundbar main unit - e.g., microwaves, wireless LAN devices, etc.