Samsung HT-F5530 User Manual

Also see for HT-F5530: User manual User manual

| 24 EnglishSettingsResetReverts all settings to their defaultsexcept for the network and SmartHub settings, and then starts theSetup function. Requires that youenter your security PIN. The defaultsecurity PIN is 0000Networks and the InternetWhen you connect this product to a network, you canuse network based applications and functions such asSmart Hub and BD-LIVE, and upgrade the product'ssoftware through the network connection. For moreinformation about accessing and using Internet services,see the Network Services chapter of this manual onpages 42~50. Instructions for configuring the networkconnection start below.Configuring Your Network ConnectionIf you didn't configure your network connection during theinitial settings procedure or you need to reset the networkconnection, follow the directions below.Before you begin, contact your Internet Service Providerto find out if your IP address is static or dynamic. If itis dynamic, and you have a wired or wireless network,we recommend using the Automatic configurationprocedures described below.If you are connecting to a wired network, connect theproduct to your router using a LAN cable before you startthe configuration procedure.To begin configuring your network connection, followthese steps:1. In the Home screen, select Settings, and thenpress the E button.2. Select Network, and then press the E button.3. Select Network Settings, and then press the Ebutton.4. Go to the instructions for Wired networks startingbelow or the instructions for Wireless networksstarting on page 25.Wired Network Wired – AutomaticAfter following Steps 1 to 3 above:1. In the Network Settings screen, change Networktype to Wired. Then, select Connect and pressthe E button. The product detects the wiredconnection, verifies the network connection andthen connects to the network.2. When it is done, highlight OK, and then press Ebutton. Wired - ManualIf you have a static IP address or the automatic proceduredoes not work, you'll need to set the Network Settingsvalues manually.After following Steps 1 to 3 above:1. In the Network Settings screen, change Networktype to Wired. Then, select Connect and press theE button.The product searches for a network, and thendisplays the connection failed message.| NOTES | If it is possible to connect the home theater to yournetwork wirelessly, select Change Network at thispoint, change the Network type to Wireless, andthen go to the instructions for wireless networks onpage 25.Network SettingsWired network connection failed.MAC Address XX:XX:XX:XX:XX:XXIP Address 0. 0. 0. 0Subnet Mask 0. 0. 0. 0Gateway 0. 0. 0. 0DNS Server 0. 0. 0. 0Unable to connect to the network. Try the following: check if your IP address isset correctly in IP Settings. Contact your Internet Service Provider for moreinformation.IP SettingsChange Network Retry Close2. Use the ◄► buttons to select IP Settings, andthen press the E button. The IP Settings screenappears.3. Select the IP Setting field, and then set it to Entermanually.4. Select a value to enter (IP Address, for example),and then press E. Use the number keypad onyour remote control to enter the numbers for thevalue. You can also enter numbers using the ▲▼buttons. Use the ◄► buttons on the remote controlto move from entry field to entry field within a value.When done with one value, press the E button.5. Press the ▲ or ▼ button to move to another value,and then enter the numbers for that value followingthe instructions in Step 4.6. Repeat Steps 4 and 5 until you have filled in allvalues.