Samsung HT-DS1750 Instruction Manual

Also see for HT-DS1750: Service manual Service manual

Contents

2143Setting the Speaker ModeSignal outputs and frequency responses from the speakers will automatically be adjustedaccording to your speaker configuration and whether certain speakers are used or not.Setting the Test TonePress the Test Tone to check the speaker connections and to adjust the speaker levels.In Stop mode,press MENUbutton.Press Cursorbutton to move to‘Audio’ and thenpress ENTER button.In the SpeakerSetup, press theENTER button again.L: Front Speaker (L) C: Center Speaker SW: SubwooferR: Front Speaker (R) LS: Rear Speaker (L) RS: Rear Speaker (R)Press Cursor , ,, buttons to moveto the desiredspeaker and thenpress ENTER button.• For C, LS, and RS, each time the buttonis pressed, the mode switchesalternately as follows: SMALL ➝ NONE.• For L and R, the mode is set to SMALL.Press RETURN button to return to the previous level.Press MENU button to exit the setup screen.51 52SETUPSMALL : Select this when using the speakers.NONE : Select this when no speakers are installed.21 In Stop mode,press MENUbutton.Press Cursorbutton to move to‘Audio’ and thenpress ENTER button. 3 Press Cursor buttonto move to ‘TESTTONE’ and then pressENTER button.• The test tone will be sent to L ➝ C ➝R ➝ RS ➝ LS ➝ SW in that order.If the ENTER button is pressed againat this time, the test tone will stop.To end the test tone,press TEST TONE button.Press TEST TONE button.• Test tone will be produced as follows:When playing a DVD or CD, this will workonly in Stop mode.• Use this function to check that each speaker iscorrectly connected and that there is no problem.When manually testing using the TEST TONE buttonMulti-Channel Pro Logic ModeStart• Depending on PRO LOGIC and STEREO, the speaker mode may vary.Note