PREPARATIONRemote Control Unit7 8DVD POWER buttonDSP/DPL II Mode buttonDSP/DPL II Effect buttonRDS Selection buttonNumber(0~9) buttonsSlow buttonAngle buttonRepeat buttonZoom buttonRepeat A↔B buttonGo To buttonD.R.C buttonTV Power buttonTV/VIDEO buttonTV Channel Selection buttonT V V o l u m e C o n t r o l b u t t o nVolumeTVChannelTV/VIDEODVD buttonTUNER buttonAUX buttonOpen/Close buttonTitle buttonMenu buttonAudio MO/ST(mono/stereo) buttonSubtitle buttonDisplay buttonReturn buttonMute buttonClear buttonVolume Control buttonsSpeaker output volume controlPlay/Pause buttonStop buttonTuning Preset/CD Skip buttonTuning Up/Down/CD Search buttonSleep buttonDirection/Enter buttonStep buttonSetup buttonRemain buttonProgram buttonSound Edit buttonSPK Mode buttonPro Logic II buttonTest Tone button30307~10mRemove the battery cover onthe back of the remote bypressing down and sliding thecover in the direction of thearrow.Insert Remote Batteries Range of Operation of the Remote Control1Insert two 1.5V AAA batteries,paying attention to the correctpolarities (+ and –).2Replace the battery cover.3The remote control can be used up toapproximately 23 feet/7 meters in a straight line.It can also be operated at a horizontal angle ofup to 30° from the remote control sensor.Follow these precautions to avoid leaking or cracking cells:• Place batteries in the remote control so they match thepolarity:(+) to (+)and (–)to (–).• Use the correct type of batteries.Batteries that look similarmay differ in voltage.• Always replace both batteries at the same time.• Do not expose batteries to heat or flame.CAUTIONTo open the remote control cover,push the top of the cover, then slidedownward.Listening on headphonesListening on headphonesUse headphones (not supplied) for private listening pleasure.Connect the headphones to the HEADPHONES jack of the front panel.• No sound is produced from the speakers.• To prevent hearing damage, do not raise the volume level excessively when using headphones.HEADPHONE jack