Samsung HT-D6730W User Manual

Contents

22 EnglishConnectionsCAUTIONDo not let children play with or near the speakers. They could get hurt if a speaker falls.When connecting the speaker wires to the speakers, make sure that the polarity (+/–) is correct.Keep the subwoofer speaker out of reach of children to prevent children from inserting their handsor alien substances into the duct (hole) of the subwoofer speaker.Do not hang the subwoofer on the wall through the duct (hole).Do not insert any other card except the TX card dedicated to the product.If you insert a different TX card, you can damage the product and may not be able to remove thecard easily.Do not insert the TX card upside down or in the reverse direction.Insert the TX card when the product is turned off. Inserting the card when it is turned on maycause a problem.The wireless receiving antenna is built into the wireless receiver module. Keep it away from waterand moisture.For optimal listening performance, make sure that the area around the wireless receiver modulelocation is clear of any obstructions.If no sound is heard from the wireless surround speakers, switch the mode to Dolby ProLogic II.In 2-CH mode, you will hear no sound from the wireless surround speakers.NOTEIf you place a speaker near your TV set, the screen color may be distorted because of the magneticfield.Place the wireless receiver module at the rear of the listening position. If the wireless receiver module istoo close to the product, sound from the speakers may be disrupted because of interference.If you use a device such as a microwave oven, wireless LAN Card, or any other device that usesthe 2.4/5.8GHz frequencies near the product, sound from the speakers may be disruptedbecause of interference.The maximum transmission distance from the product to the wireless receiver module is about 33feet (10m), but may vary depending on your operating environment. If a steel-concrete wall ormetallic wall is between the product and the wireless receiver module, the system may not operateat all, because the radio wave cannot penetrate metal.If the product doesn't make a wireless connection, you need to run an ID Set between theproduct and wireless receiver module. With the product turned off, press "0""1""3""5" onthe remote control. Turn on the wireless receiver module. Then, press and hold the “ID SET”button on the back of the wireless receiver module for 5 seconds, and then turn the product on.Attaching the Toroidal Ferrite Core to the Power Cord of the Main UnitIf you attach a Toroidal ferrite core to the power cord of the man unit, it will help to prevent RFinterference from radio signals.Pull the fixing tab of the Toroidal ferrite core to open it.Make a loop twice in the main unit power cord.Attach the Toroidal ferrite core to the main unit power cordas the figure shows and press it until it clicks.!✎1.2.3. FRONT FRONT TOPSPEAKERS OUTFM ANTWIRELESS VIDEO OUTAUX INSUBWOOFERCENTER FRONT FRONT TOPCOMPONENT OUTSPEAKER IMPEDANCE : 3HT-D6730W_XAA_1226.indd 22HT-D6730W_XAA_1226.indd 22 2011-12-26 5:45:522011-12-26 5:45:52