Samsung HT-C553 User Manual

Also see for HT-C550: User manual User manual User manual User manual Firmware update

Contents

English 102 ConnectionsPress down the terminal tab on the back of the speaker.Insert the black wire into the black terminal (–) and the red wire into the redterminal (+), and then release the tab.Connect the connecting plugs to the back of the product by matching thecolours of the speaker plugs to the speaker jacks.With the product turned off, insert the TX card into theTX Card Connection (WIRELESS) on the back of the product.Hold the TX card so that the label "WIRELESS" faces upward and insertthe card into the port.The TX card enables communication between the product and thewireless receiver module.Connect the left and right rear speakers to the wireless Receiver module.Plug the power cord of the wireless Receiver module in the wall outlet .1.2.3.4.~~5.6.DIGITALAUDIO INOPTICALWIRELESSFM ANTHDMI OUTAUX IN 2 COMPONENTOUTVIDEOOUTDIGITALAUDIO INOPTICALHDMI OUTAUX IN 2 COMPONENTOUTVIDEOOUTWIRELESSTX cardConnectionsBlack RedNOTEThe rear speakers for HT-C550/C553/C555 can also be connected to the Wireless Receiver Module (SWA-5000)ifyou purchase it separately.Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close tothe product, some sound interruption may be heard due to interference.If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device thatuses the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due tointerference.The transmission distance from the product to the wireless receiver module is about 10m, but may vary dependingon your operating environment. If a steel-concrete wall or metallic wall is between the product and the wirelessreceiver module, the system may not operate at all, because the radio wave cannot penetrate metal.If the product doesn't make wireless connection, the product needs ID Setting between the product and wirelessreceiver module. With the product turned off, press remote control's number buttons "0""1""3""5" and themessage "W INIT" will appear on the display.With the wireless receiver module turned on, press "ID SET" button on the back of the wireless receiver module for5 seconds.CAUTIONDo not insert any other card except the provided TX card.If a different TX card is used, the product may be damaged or the card may not be removed easily.Do not insert the TX card upside down or in the reverse direction.Insert the TX card when the product is turned off. Inserting the card when it is turned on may cause a problem.If the TX Card is inserted and wireless receiver module setting is complete, sound is not output from the rearSpeaker connectors on the product.The wireless receiver antenna is built into the wireless receiver module. Keep it away from water and moisture.For optimal listening performance, make sure that the area around the wireless receiver module location is clear ofany obstructions.If no sound is heard from the wireless receiver module, switch the mode to DVD 5.1 channel or DolbyProLogic II .In 2-CH mode, no sound will be heard from the wireless receiver module.✎``````!````````Downloaded From TheatreSystem-Manual.com Manuals