35noitamrofniytefasdnahtlaeHphysical dimensions, construction, and electrical and RF characteristics.This USB Modem must not be collocated or operate in con-junction withany other antenna or transmitter. Use of this device in any otherconfiguration may exceed the FCC RF Exposure compliance limit.SAR information on this and other model devices can be viewed on-lineat www.fcc.gov/oet/fccid. This site uses the device FCC ID number,A3LGTB1110. Sometimes it may be necessary to remove the batterypack to find the number. Once you have the FCC ID number for aparticular device, follow the instructions on the website and it shouldprovide values for typical or maximum SAR for a particular device.Additional product specific SAR information can also be obtained atwww.fcc.gov/cgb/sar.Consumer Information on devicesThe U.S. Food and Drug Administration (FDA) has published a series ofQuestions and Answers for consumers relating to radio frequency (RF)exposure from devices. The FDA publication includes the followinginformation:What kinds of pdevices are the subject of this update?The term device refers here to hand-held devices with built-inantennas, often called cell,mobile,or PCSdevices. These types ofdevices can expose the user to measurable radio frequency energy(RF) because of the short distance between the device and the user’shead. These RF exposures are limited by Federal CommunicationsCommission safety guidelines that were developed with the advice ofFDA and other federal health and safety agencies. When the device islocated at greater distances from the user, the exposure to RF is