Samsung Freezer User Manual

Also see for Freezer: User manual User manual

Contents

12_ setting up12_ setting up7. Separate the hinge shaft by using hex wrenchfirst. Unscrew the bolt to remove the hinge riserand switch the side of the hinge shaft and thehinge riser.8. Attach the hinge on the bottom right side of thefreezer where bolts were previously removed instep 6. Screw the bolts that were removed onthe bottom left side of the freezer for the futureusage.9. Remove the screws on the bottom right and leftside of the freezer door. Switch the side of thedoor stopper from left to the right. Hinge risershould be switched as well.10.Remove the wire cover on top of the freezer doorto switch the side of the wires.11.Remove the hinge and the grommet from thefreezer door. Detach the left side hinge cover andpull the wires out of the hinge cover.Be careful not to damage the electrical wireswhen removing the hinge cover.2. Remove the plastic cover and make sure todisconnect the wire connected to it.After removing the plastic cover, check the partsfor reversing the door.Be careful not to damage the electrical wireswhen removing the plastic cover.3. Disconnect the wires and then remove 3 bolts.Make sure your freezer is unplugged beforehandling electrical wires.4. Remove the door from the lower hinge bycarefully lifting the door straight up.Freezer door is heavy, be careful not to injureyourself when removing the freezer door.5. Separate the front leg cover after removing 2screws.6. Unscrew 3 bolts tightening the hinge and alsounscrew 3 bolts on the bottom right side by thefront leg where removed hinge will be attached.CAUTIONCAUTIONWARNINGScrewsScrews10mm10mm10mm10mmHinge shaftHinge shaft8mm Bolt8mm BoltHinge riserHinge riser10mm10mm10mm10mmHinge riserHinge riser Hinge riserHinge riserHinge coverHinge coverGrommetGrommetCAUTIONDA99-01951A (EN)-16.indd 12DA99-01951A (EN)-16.indd 12 13. 4. 20. 1:4913. 4. 20. 1:49